An IDE driver for NEC VR5701-SG2 Board

PATCH New Sergey Podstavin 1 participant 1 message May 31, 2005 MIPS

lore

Share & tools

lore

Sergey Podstavin

author

2005-05-31 14:25 UTC #0 lore raw

PATCH 1/1 An IDE driver for NEC VR5701-SG2 Board

Hi Bartlomiej!

Attached is an IDE driver for NEC VR5701-SG2 Board. It works on CPU VR5701 internal IDE interface. The IDE has the same vendor ID and Device ID for internal USB interface, so the driver check class ID. Please review it.

Best wishes,
Sergey Podstavin.

drivers/ide/Kconfig +6 -0

diff -Naurp --exclude=CVS linux_save/drivers/ide/Kconfig linux_mips/drivers/ide/Kconfig
@@ -835,6 +835,12 @@ config BLK_DEV_GAYLE
 	  Note that you also have to enable Zorro bus support if you want to
 	  use Gayle IDE interfaces on the Zorro expansion bus.
 
+config BLK_DEV_NEC_VR5701_SG2
+	bool "NEC VR5701-SG2 IDE interface support"
+	depends on TCUBE
+	help
+	  This is the IDE driver for the NEC VR5701-SG2 IDE interface. 
+
 config BLK_DEV_IDEDOUBLER
 	bool "Amiga IDE Doubler support (EXPERIMENTAL)"
 	depends on BLK_DEV_GAYLE && EXPERIMENTAL

drivers/ide/pci/Makefile +1 -0

diff -Naurp --exclude=CVS linux_save/drivers/ide/pci/Makefile linux_mips/drivers/ide/pci/Makefile
@@ -27,6 +27,7 @@ obj-$(CONFIG_BLK_DEV_SLC90E66)		+= slc90
 obj-$(CONFIG_BLK_DEV_TRIFLEX)		+= triflex.o
 obj-$(CONFIG_BLK_DEV_TRM290)		+= trm290.o
 obj-$(CONFIG_BLK_DEV_VIA82CXXX)		+= via82cxxx.o
+obj-$(CONFIG_BLK_DEV_NEC_VR5701_SG2)	+= nec_vr5701_sg2.o
 
 # Must appear at the end of the block
 obj-$(CONFIG_BLK_DEV_GENERIC)          += generic.o

drivers/ide/pci/nec_vr5701_sg2.c +111 -0

111 lines not on this page · raw message