yenta_socket: no PCI interrupts after resume if intel-agp loaded on HP 1105
If I boot a kernel without any modules loaded and then load intel-agp, I can successfully suspend and resume this machine via ACPI. However, the b44 module is then unable to determine its MAC address correctly, and ipw2100 claims that it can't find a device. yenta_socket gives
Yenta : Enabling burst memory read transactions
Yenta: Using CSCINT to route CSC interrupts to PCI
Yenta: Routing CardBus interrupts to PCI
Yenta TI: socket 0000:02:06.0, mfunc 0x00001000, devctl 0x66 Yenta TI: socket 0000:02:06.0 probing PCI interrupt failed, trying to fix Yenta TI: socket 0000:02:06.0 falling back to parallel PCI interrupts Yenta TI: socket 0000:02:06.0 no PCI interrupts. Fish. Please report.
The only output from the AGP driver is:
agpgart: Detected an Intel 855PM Chipset.
agpgart: AGP aperture is 32M @ 0xe2000000
If I have all of these drivers loaded at suspend, resume fails. Without intel-agp, I can suspend and resume happily (well, X won't start after resume, but that's potentially an entirely separate issue)
Signature · 9 lines
Matthew Garrett | [email protected] ------------------------------------------------------- This SF.Net email is sponsored by: NEC IT Guy Games. How far can you shotput a projector? How fast can you ride your desk chair down the office luge track? If you want to score the big prize, get to know the little guy. Play to win an NEC 61" plasma display: http://www.necitguy.com/?r=20
Quoted 4 lines
If I have all of these drivers loaded at suspend, resume fails. Without intel-agp, I can suspend and resume happily (well, X won't start after resume, but that's potentially an entirely separate issue)
I've tracked this down some further. If I comment out these lines in intel_845_configure:
/* agpm */
pci_read_config_byte(agp_bridge->dev, INTEL_I845_AGPM, &temp2);
pci_write_config_byte(agp_bridge->dev, INTEL_I845_AGPM, temp2 |(1 << 1));
then I can load intel-agp, suspend and resume and still get correct interrupts. If I leave then uncommented, then attempting to load yenta-socket after a suspend/resume with intel-agp loaded results in the "no PCI interrupts. Fish" error. This is an i855PM device using nvidia graphics.
Signature · 1 line
Matthew Garrett | [email protected]