aacraid: correct use of cmd->timeout field

timeout_per_command.

The cmd->timeout field has been obsolete for a while now. While looking to remove it, I came across this use in the aacraid driver. It looks like you want to initialise the firmware with the current timeout of the command (in seconds), so the value I think you should be using is cmd-

Quoted 1 line

timeout_per_command.

James

drivers/scsi/aacraid/aachba.c +1 -1

@@ -1894,7 +1893,7 @@ static int aac_send_srb_fib(struct scsi_
 	srbcmd->id   = cpu_to_le32(scsicmd->device->id);
 	srbcmd->lun      = cpu_to_le32(scsicmd->device->lun);
 	srbcmd->flags    = cpu_to_le32(flag);
-	timeout = (scsicmd->timeout-jiffies)/HZ;
+	timeout = scsicmd->timeout_per_command/HZ;
 	if(timeout == 0){
 		timeout = 1;
 	}