adjust initialization order
RFC 2/2 adjust initialization order
Hi,
adjust the initialization order slightly, so PCI device enumeration is after ACPI device enumeration.
Thanks,
Shaohua
---
linux-2.6.13-root/drivers/acpi/Makefile | 6 +- linux-2.6.13-root/drivers/acpi/scan.c | 66 +++++++++++++++++++++++++------- 2 files changed, 56 insertions(+), 16 deletions(-)
drivers/acpi/Makefile renamed from drivers/acpi/Makefile~adjust_init_order +3 -3
@@ -37,6 +37,9 @@ endif obj-$(CONFIG_ACPI_BUS) += sleep/ obj-$(CONFIG_ACPI_BUS) += bus.o glue.o +obj-$(CONFIG_ACPI_SYSTEM) += system.o event.o +obj-$(CONFIG_ACPI_DEBUG) += debug.o +obj-$(CONFIG_ACPI_BUS) += scan.o motherboard.o obj-$(CONFIG_ACPI_AC) += ac.o obj-$(CONFIG_ACPI_BATTERY) += battery.o obj-$(CONFIG_ACPI_BUTTON) += button.o
@@ -49,11 +52,8 @@ obj-$(CONFIG_ACPI_POWER) += power.o obj-$(CONFIG_ACPI_PROCESSOR) += processor.o obj-$(CONFIG_ACPI_CONTAINER) += container.o obj-$(CONFIG_ACPI_THERMAL) += thermal.o -obj-$(CONFIG_ACPI_SYSTEM) += system.o event.o -obj-$(CONFIG_ACPI_DEBUG) += debug.o obj-$(CONFIG_ACPI_NUMA) += numa.o obj-$(CONFIG_ACPI_ASUS) += asus_acpi.o obj-$(CONFIG_ACPI_IBM) += ibm_acpi.o obj-$(CONFIG_ACPI_TOSHIBA) += toshiba_acpi.o -obj-$(CONFIG_ACPI_BUS) += scan.o motherboard.o obj-$(CONFIG_ACPI_HOTPLUG_MEMORY) += acpi_memhotplug.o
drivers/acpi/scan.c renamed from drivers/acpi/scan.c~adjust_init_order +53 -13
84 lines not on this page · raw message
_
-------------------------------------------------------
SF.Net email is Sponsored by the Better Software Conference & EXPO September 19-22, 2005 * San Francisco, CA * Development Lifecycle Practices Agile & Plan-Driven Development * Managing Projects & Teams * Testing & QA Security * Process Improvement & Measurement * http://www.sqe.com/bsce5sf