Skip to contentSkip to conversation

CPU utilization and hyperthreading

DISCUSSION [email protected] 2 participants 2 messages Nov 6, 2005

lore
Share & tools
lore
#0 lore raw

Hi,

I'm using a 2.6.4-52 (Suse 9.1 pro distribution) kernel on a 3.2 dual XEON machine (with hyperthreading).

I'm trying to analyze the performance of a kernel module that contains 4 kernel threads (3 of them are more active). Also, some of the work is done in a tasklet. The CPU load (as shown in vmstat) doesn't reach more than 50%. When trying to artificially stress the system with some useless loops, the CPU load reaches 65% (but I cannot reach 100%). Also, the interrupts count in vmstat is around 20000 (1000 when idle).

My questions are:
1. Why can't I reach 100%?
2. I guess that since I have 4 virtual CPUs (as shown in /proc/cpuinfo), not all of them are stressed. Is there a way to see the CPU utilization for each CPU (vmstat doesn't allow that)?
3. When I load a module with a kernel thread that runs an infinite loop, I get 25% CPU utilization (50% if I run 2 threads). Is it because I'm using 100% of a single CPU (out of 4)?
4. How is the time spent in interrupt context estimated? Is it possible to view it somehow?

Thanks
Erez

#1 lore raw
Quoted 12 lines · On Sunday 06 November 2005 16:13, [email protected] wrote:

Hi,

I'm using a 2.6.4-52 (Suse 9.1 pro distribution) kernel on a 3.2 dual XEON machine (with hyperthreading).

I'm trying to analyze the performance of a kernel module that contains 4 kernel threads (3 of them are more active). Also, some of the work is done in a tasklet. The CPU load (as shown in vmstat) doesn't reach more than 50%. When trying to artificially stress the system with some useless loops, the CPU load reaches 65% (but I cannot reach 100%). Also, the interrupts count in vmstat is around 20000 (1000 when idle).

Quoted 2 lines

My questions are:
1. Why can't I reach 100%?

You can.

# while true; do true; done &
# while true; do true; done &
# while true; do true; done &
# while true; do true; done &
Quoted 3 lines

2. I guess that since I have 4 virtual CPUs (as shown in /proc/cpuinfo), not all of them are stressed. Is there a way to see the CPU utilization for each CPU (vmstat doesn't allow that)?

top

Quoted 5 lines

3. When I load a module with a kernel thread that runs an infinite loop, I get 25% CPU utilization (50% if I run 2 threads). Is it because I'm using 100% of a single CPU (out of 4)?
4. How is the time spent in interrupt context estimated? Is it possible to view it somehow?

--
vda