Skip to contentSkip to conversation

p4-clockmod help

DISCUSSION Nigel Cunningham 1 participant 1 message Dec 12, 2005 3 messages not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

#3 lore raw

Hi again Pat et al.

Quoted 16 lines · Pat Double
Quoted 5 lines · Bojan Smojver
Quoted 2 lines · Pat Double

Has anyone been successful resuming with the p4-clockmod module loaded, or compiled in?

It works on my notebook with FC Rawhide kernels and suspend2.

It does not work well here. I believe it is because I have a P4 HT, the SMP part is causing problems. I get a BUG sometime after it starts writing the image. Normally it happens while writing the image but can also happen during the atomic copy. I tried to disable calls to change the freq during suspend but I do not even get the suspend function called until the atomic copy, so the bug happens before then. I do not know how to fix this.

Nigel, any help?

Quoted 7 lines

I get a BUG at p4-clockmod.c, line 142:
BUG_ON(smp_processor_id() != i);

The error is an invalid operand 0000

Also, writing the image becomes VERY slow with p4-clockmod loaded. I do not have any governer loaded except performance.

Since any fix should come from the cpufreq guys, and they'll understand the issue better than me, I want to refer the problem to them...

Cqufreq guys, I've only had a superficial look at this, but this BUG_ON appears to be triggering because hot unplugging of cpu1 is not being taken into account. Can you please help?

Regards,

Nigel