LED: Add NAND MTD activity LED trigger
Subsystems (2)
PATCH 11/11 LED: Add NAND MTD activity LED trigger
drivers/mtd/nand/nand_base.c +25 -1
@@ -80,6 +80,7 @@#include <linux/mtd/compatmac.h> #include <linux/interrupt.h> #include <linux/bitops.h> +#include <linux/leds.h> #include <asm/io.h> #ifdef CONFIG_MTD_PARTITIONS
@@ -515,6 +516,8 @@return nand_isbad_bbt (mtd, ofs, allowbbt); } +INIT_LED_TRIGGER (nand_led_trigger); +/* * Wait for the ready pin, after a command * The timeout is catched later.
@@ -524,12 +527,14 @@struct nand_chip *this = mtd->priv;unsigned long timeo = jiffies +2 ; +led_trigger_event (nand_led_trigger,LED_FULL );/* wait until command is processed or timeout occures */ do {if (this->dev_ready (mtd)) -return ; +break ;touch_softlockup_watchdog (); }while (time_before (jiffies, timeo)); +led_trigger_event (nand_led_trigger,LED_OFF ); }/**
@@ -817,6 +822,8 @@else timeo += (HZ *20 ) /1000 ; +led_trigger_event (nand_led_trigger,LED_FULL ); +/* Apply this short delay always to ensure that we do wait tWB in * any case on any machine. */ ndelay (100 );
@@ -840,6 +847,8 @@ }cond_resched (); } +led_trigger_event (nand_led_trigger,LED_OFF ); + status = (int ) this->read_byte (mtd);return status; }
@@ -2724,6 +2733,21 @@EXPORT_SYMBOL_GPL (nand_scan);EXPORT_SYMBOL_GPL (nand_release); + +static int __init nand_base_init (void ) +{ +led_trigger_register_simple ("nand-disk" , &nand_led_trigger); +return 0 ; +} + +static void nand_base_exit (void ) +{ +led_trigger_unregister_simple (nand_led_trigger); +} + +module_init (nand_base_init); +module_exit (nand_base_exit); +MODULE_LICENSE ("GPL" );MODULE_AUTHOR ("Steven J. Hill <[email protected]>, Thomas Gleixner <[email protected]>" );MODULE_DESCRIPTION ("Generic NAND flash driver code" );