Skip to contentSkip to conversation

OSK5912 Deep Sleep

DISCUSSION Martin Margraf 2 participants 4 messages May 18, 2006 – May 21, 2006

lore
Share & tools
lore
#0 lore raw

hi,

maybe my questions are too simple, but i?ll try again.
how can i set the osk5912 into deep sleep mode? i use the montavista preview kit. thx.

martin

#1 lore raw

G'Day,

Quoted 3 lines

maybe my questions are too simple, but i?ll try again. how can i set the osk5912 into deep sleep mode? i use the montavista preview kit.

Deep Sleep is nice and easy to do. Try this at a prompt:
# echo "standby" > /sys/power/state
Unless something goes wrong, your system will now be in Deep Sleep.

-- Matthew

#2 lore raw
In reply to Martin Margraf

hi matthew,

thanks for your answer.
i tried what you told me, but i got this message from the shell: cannot create /sys/power/state: No such file or directory so i looked for the sys directory and found it in /usr/include/sys, is this the right one?
may i have to export it to PATH? or is the 2.4 kernel the wrong one and i should use 2.6 kernel?
you have to excuse me, but i am a total newbie to embedded linux. its the first time i use it. ;)

martin

#3 lore raw

G'Day,

Quoted 2 lines

i tried what you told me, but i got this message from the shell: cannot create /sys/power/state: No such file or directory

Ah, you either have not compiled the sysfs into kernel, or have not
mounted it. Ensure you have CONFIG_SYSFS=y in your kernel's .config (this is in the root source directory) --- =m is also OK, if you load the module later. If not, enable it, and recompile. Then, make sure you have the following line in your OSK's /etc/fstab:
none /sys sysfs defaults 0 0
This will load the sysfs on boot (make sure you have created /sys/ for it to mount there). If you check the contents of /sys/ (with ls) after it has been mounted, you should see a collection of directories: these can be very useful to running your system.

-- Matthew