scx200_acb: Documentation update
PATCH 34/44 scx200_acb: Documentation update
From: Jean Delvare <khali at linux-fr.org>
Documentation update for the scx200_acb driver. Hopefully this will help future users.
References:
[lm-sensors] Support of i2c-nscacb (April, May 2005)
http://lists.lm-sensors.org/pipermail/lm-sensors/2005-April/011756.html
http://lists.lm-sensors.org/pipermail/lm-sensors/2005-May/012043.html
[lm-sensors] making a geode i2c slave driver (April 2006)
http://lists.lm-sensors.org/pipermail/lm-sensors/2006-April/015998.html
Kernel bug #6445
http://bugzilla.kernel.org/show_bug.cgi?idd45
Signed-off-by Jean Delvare <khali at linux-fr.org>
Signed-off-by Greg Kroah-Hartman <gregkh at suse.de>
--- Documentation/i2c/busses/scx200_acb | 19 ++++++++++++++++++- 1 files changed, 18 insertions(+), 1 deletions(-)
Documentation/i2c/busses/scx200_acb +18 -1
@@ -2,14 +2,31 @@ Kernel driver scx200_acb Author: Christer Weinigel <wingel at nano-system.com> +The driver supersedes the older, never merged driver named i2c-nscacb. + Module Parameters ----------------- -* base: int +* base: up to 4 ints Base addresses for the ACCESS.bus controllers on SCx200 and SC1100 devices + By default the driver uses two base addresses 0x820 and 0x840. + If you want only one base address, specify the second as 0 so as to + override this default. + Description ----------- Enable the use of the ACCESS.bus controller on the Geode SCx200 and SC1100 processors and the CS5535 and CS5536 Geode companion devices. + +Device-specific notes +--------------------- + +The SC1100 WRAP boards are known to use base addresses 0x810 and 0x820. +If the scx200_acb driver is built into the kernel, add the following +parameter to your boot command line: + scx200_acb.base=0x810,0x820 +If the scx200_acb driver is built as a module, add the following line to +the file /etc/modprobe.conf instead: + options scx200_acb base=0x810,0x820
Signature · 1 line
1.4.0