Skip to contentSkip to conversation

JMicron SATA/IDE and 2.6.18-rc4 fails to detect CDROM

DISCUSSION mikepolniak 3 participants 3 messages Aug 17, 2006

lore
Share & tools
lore
#0 lore raw

Using 2.6.18-rc4 and CONFIG_SCSI_SATA_AHCI=m, fails to detect ide cdrom.

lspci

03:00.1 IDE interface: JMicron Technologies, Inc. JMicron 20360/20363 AHCI
Controller (rev02)

and from dmesg|grep -i ide

BIOS-provided physical RAM map:
ACPI: IRQ0 used by override.
ACPI: IRQ2 used by override.
ACPI: IRQ9 used by override.
Boot video device is 0000:01:00.0
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx Probing IDE interface ide0...
Probing IDE interface ide1...

If i modprobe ahci dmesg shows:

ahci 0000:03:00.0: version 2.0
ACPI: PCI Interrupt 0000:03:00.0[A] -> GSI 19 (level, low) -> IRQ 17 PCI:
Setting latency timer of device 0000:03:00.0 to 64 ahci 0000:03:00.0:
AHCI
0001.0000 32 slots 2 ports 3 Gbps 0x3 impl SATA mode ahci 0000:03:00.0:
flags: 64bit ncq pm led clo pmp pio slum part ata5: SATA max UDMA/133 cmd 0xFFFFC2000002C100 ctl 0x0 bmdma 0x0 irq 17 ata6: SATA max UDMA/133 cmd 0xFFFFC2000002C180 ctl 0x0 bmdma 0x0 irq 17 scsi6 : ahci
ata5: SATA link down (SStatus 0 SControl 300) scsi7 : ahci
ata6: SATA link down (SStatus 0 SControl 300)

The BIOS sees the CDROM but it is not detected by ide driver.

#1 lore raw
Quoted 7 lines · mikepolniak

Using 2.6.18-rc4 and CONFIG_SCSI_SATA_AHCI=m, fails to detect ide cdrom.

lspci

03:00.1 IDE interface: JMicron Technologies, Inc. JMicron 20360/20363 AHCI
Controller (rev02)

is it a SATA or PATA cdrom?

Jeff

#2 lore raw
In reply to mikepolniak

Ar Iau, 2006-08-17 am 10:01 -0400, ysgrifennodd mikepolniak:

Quoted 1 line

Using 2.6.18-rc4 and CONFIG_SCSI_SATA_AHCI=m, fails to detect ide cdrom.

rc4 support for the PATA ports on the jmicron is broken. Please try rc4-mm1 if you need it. A patch went to Greg a while ago so it should I hope be fixed in rc5

Alan