Add support for Errata DDR6 on MPC 834x systems
PATCH 1/1 Add support for Errata DDR6 on MPC 834x systems
From: Timur Tabi <[email protected]>
CHANGELOG:
* Errata DDR6, which affects all current MPC 834x processors, lists changes required to maintain compatibility with various types of DDR memory. This patch implements those changes.
Signed-off-by Timur Tabi <[email protected]>
--- cpu/mpc83xx/spd_sdram.c | 41 +++++++++++++++++++++++++++++++++++++++++ 1 files changed, 41 insertions(+), 0 deletions(-)
cpu/mpc83xx/spd_sdram.c +41 -0
@@ -112,6 +112,9 @@ long int spd_sdram()unsigned int law_size;unsigned char caslat;unsigned int trfc, trfc_clk, trfc_low; +#ifdef CONFIG_MPC834X +int caslat_83xx;/* For Errata DDR6 */ +#endif CFG_READ_SPD (SPD_EEPROM_ADDRESS ,0 ,1 , (uchar *) & spd,sizeof (spd));#ifdef SPD_DEBUG
@@ -222,6 +225,40 @@ #endifreturn 0 ; } +#ifdef CONFIG_MPC834X +/* Errata DDR6 +This errata affects all MPC8349E, MPC8343E and MPC8347E processors. +*/ +if ((tmp1 >=280 ) && (tmp1 <350 ))/* CSB=333 */ + { +if (spd.mid[0 ] ==0x2c ) { +/* Micron memory running at 333 MHz */ +/* Chances are, U-Boot will crash before we get here, +but just in case, display a message and return error. */ +printf ("Micron DDR not supported@333MHz CSB\n" ); +return 0 ; + }else if (spd.mid[0 ] ==0xad ) { +printf ("Hynix DDR does not require Errata DDR6\n" ); + }else { +/* enable 2 cycle Earlier for CL=2.5 or 3 */ + ddr->debug_reg =0x202c0000 ; +printf ("Errata DDR6 (debug_reg=0x%x)\n" , ddr->debug_reg); + } + caslat_83xx = caslat; + } + +if ((tmp1 >=230 ) && (tmp1 <280 )) {/* CSB=266 */ +if (spd.mid[0 ] !=0x2c )/* non-Micron */ + caslat_83xx = caslat -1 ; + + } + +if ((tmp1 >=90 ) && (tmp1 <230 )) {/* CSB=200 */ + caslat =3 ; + caslat_83xx =2 ; + } +#endif +/* * note: caslat must also be programmed into ddr->sdram_mode * register.
@@ -237,7 +274,11 @@ #endif (((picos_to_clk (spd.trp *250 ) &0x07 ) <<28 ) | ((picos_to_clk (spd.tras *1000 ) &0x0f ) <<24 ) | ((picos_to_clk (spd.trcd *250 ) &0x07 ) <<20 ) | +#ifdef CONFIG_MPC834x + ((caslat_83xx &0x07 ) <<16 ) | +#else ((caslat &0x07 ) <<16 ) | +#endif (trfc_low <<12 ) | (0x300 ) | ((picos_to_clk (spd.trrd *250 ) &0x07 ) <<4 ) |1 );
Signature · 1 line
1.4.2