Skip to contentSkip to conversation

Add Marvell Phy and RGMII support to eTSEC [...]

PATCH New DENX Support System 1 participant 1 message Oct 20, 2006

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 Add Marvell Phy and RGMII support to eTSEC [...]

Hello list,

inside the automatic U-Boot patch tracking system a new ticket [DNX#2006102042000014] was created:

<snip>

Quoted 39 lines

This sets up the eTSEC and the Marvel Phy to support 10M, 100M and 1000M rates when configured in RGMII mode.

CHANGELOG:

* Add eTSEC support for RGMII mode 10M, 100M & 1000M rates

drivers/tsec.c +3 -4
index 7ec565c..6cc6444 100644
@@ -583,11 +583,10 @@ static void adjust_link(struct eth_devic
 				regs->maccfg2 =
 ((regs->maccfg2&~(MACCFG2_IF))
 					| MACCFG2_MII);
 
-				/* If We're in reduced mode, we need
-				 * to say whether we're 10 or 100 MB.
+				/* Set R100 bit in all modes although
+				 * it is only used in RGMII mode
 				 */
-				if ((priv->speed == 100)
-				    && (priv->flags & TSEC_REDUCED))
+				if (priv->speed == 100)
 					regs->ecntrl |= ECNTRL_R100;
 				else
drivers/tsec.c +1 -0
 					regs->ecntrl &= ~(ECNTRL_R100);
@@ -785,6 +784,7 @@ struct phy_info phy_info_M88E1111S = {
 		{0x1d, 0x5, NULL},
 		{0x1e, 0x0, NULL},
 		{0x1e, 0x100, NULL},
+		{0x14, 0x0cd2, NULL}, /* Add delay to RGMII TX and RX */
 		{MIIM_GBIT_CONTROL, MIIM_GBIT_CONTROL_INIT, NULL},
 		{MIIM_ANAR, MIIM_ANAR_INIT, NULL},
 		{MIIM_CONTROL, MIIM_CONTROL_RESET, NULL},
Signature · 1 line
1.4.2.3

</snip>

Your U-Boot support team