Skip to contentSkip to conversation

mpc8641d and CONFIG_VERY_BIG_RAM

U-Boot-Users Chris Fester 2 participants 2 messages Feb 26, 2007

lore
Share & tools
lore
#0 lore raw

Hi all,

We're in the process of bringing up our custom board which has an mpc8641d part on it. I've been basing most of my u-boot code off of the jdl git tree's MPC8641HPCN platform.

In the file include/configs/MPC8641HPCN.h, CONFIG_VERY_BIG_RAM is set. But I'd like to know why, or more specifically, what was the original intent of this parameter. Currently with my configuration it has the effect of relocating u-boot just below 256MB, even though I have a gig of memory on the board.

If I undefine CONFIG_VERY_BIG_RAM, the effect is more of what we desire. In particular, u-boot gets relocated to the very top of memory. This makes dram tests much easier to run, since we can run them with one big range of memory, rather than having to split into two ranges.

After some greps of the code I see comments like this:

#define CONFIG_VERY_BIG_RAM /* we will use up to 256M memory for cause
we are short of BATS*/

/* Define CONFIG_VERY_BIG_RAM to allow use of SDRAMs larger than 256MBytes

But what's interesting is the only place it seems to be used is in lib_ppc/board.c:

#ifndef	CONFIG_VERY_BIG_RAM
	addr = CFG_SDRAM_BASE + gd->ram_size;
#else
	/* only allow stack below 256M */
	addr = CFG_SDRAM_BASE +
	       (gd->ram_size > 256 << 20) ? 256 << 20 : gd->ram_size;

#endif

Is the comment about the stack below 256M a historical one for older cpus? Or will I be facing problems later if my stack is higher than that?

Thanks for any hints and/or insight! :)
Chris

#1 lore raw
Quoted 5 lines

In the file include/configs/MPC8641HPCN.h, CONFIG_VERY_BIG_RAM is set. But I'd like to know why, or more specifically, what was the original intent of this parameter. Currently with my configuration it has the effect of relocating u-boot just below 256MB, even though I have a gig of memory on the board.

CONFIG_VERY_BIG_RAM was defined because we have 1G DDR2 on MPC8641HPCN board. If your board has 256MB DDR, you don't need to define this.

Haiying