tc / MARK question
Hi Dan,
Quoted 15 lines
Hi,
I have a router, running iptables & tc, with 2 interfaces (eth0 & eth1).
I classify http traffic in iptables (prerouting mangle) coming in on eth0 and going out on eth1 with MARK
0x1, and I also classify return http traffic coming from eth1 -> eth0 with MARK0x1as well. I then ACCEPT them in the filter/FORWARD chain based on --mark0x1.However, I want to shape this traffic, and limit based on the
0x1MARK. I want to limit traffic to 4MBit outgoing on eth1 (incoming http), and 4MBit outgoing on eth0 (return http), *independently*, even though they use the same MARK.
Quoted 6 lines
If I use HTB, assigned to egress eth0 and another assigned to eth1, and classify packets based on the MARK
0x1(from above this is two tcp streams in different connections under the same mark), does tc:a) Treat the interfaces separately, giving me 4MBit either way independently
This is the correct answer.
Traffic Control is applied to each interface independently. Didn't you notice that when you configure a qdisc/class/filter you must always specify the interface name ? :)
The fact that you use the same MARK in both directions has no influence at all on the queueing.
Quoted 2 lines
b) Treat the interfaces as one (because one MARK is being used), and give me 4MBit total across both streams?
Regards
/Christian
[http://benve.info]
_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc