Skip to contentSkip to conversation

Real Time scheduler infos

DISCUSSION Ivan Gualandri 2 participants 2 messages Dec 17, 2009

lore
Share & tools
lore
#0 lore raw

Hi,

i have a question about priorities in RT patchset.

In linux priorites are from 1 to 139 (1 highest - 139 lowest) And RT prorities are between 1 to 99. An i think 1 is highest and 139 lowest.

But now if i try to launch three tasks with 3 different priorities:
for example
A has priority 10
B has priority 20
C has priority 30
I notice that the tasks B and C are always the first two to run. And A always wait the end of B or C (also if A is the first task launched).

Now my question is:
when i set priority of a RT task (changing the sched_priority field of my task) the highest priority is 99 or 1?

Thanks,
--i

P.s. Sorry for my bad english!

#1 lore raw
Quoted 16 lines · Ivan Gualandri

Hi,

i have a question about priorities in RT patchset.

In linux priorites are from 1 to 139 (1 highest - 139 lowest) And RT prorities are between 1 to 99. An i think 1 is highest and 139 lowest.

But now if i try to launch three tasks with 3 different priorities:
for example
A has priority 10
B has priority 20
C has priority 30
I notice that the tasks B and C are always the first two to run. And A always wait the end of B or C (also if A is the first task launched).

Quoted 3 lines

Now my question is:
when i set priority of a RT task (changing the sched_priority field of my task) the highest priority is 99 or 1?

The user exposed priorities are from low to high, that is 1 is the lowest and 99 (POSIX compliant apps use sched_get_priority_max(SCHED_FIFO)) is the highest priority, as specified by POSIX.

The scheduler implementation has this reversed but that should be of no consequence.