Skip to contentSkip to conversation

PROBLEM: serial port receive buffers not being flushed properly

DISCUSSION Paul Fulghum 1 participant 1 message Jul 27, 2007

lore
Share & tools
lore
#0 lore raw

From: [email protected]

Quoted 7 lines

[1.] PROBLEM: serial port receive buffers not being flushed properly [2.] After calling tcflush() or ioctl() with the TCFLSH argument, an ioctl() with the FIONREAD argument reports 0 bytes available for reading. However, a subsequent select() and read() of the port returns data. This problem is seen in 2.6.21.1 and 2.6.20, but is not seen in version 2.6.17.14. Other versions have not been tested.

There is receive buffering between the serial driver and line discipline. The line discipline processes FIONREAD and TCFLSH with regard to the line discipline receive buffers but not the intermediate buffering.

In 2.6.17 the intermediate buffering pushed receive data to the line discipline without regard for tty->receive_room, so if the ldisc buffers were full the data was lost.

In 2.6.18 the intermediate buffering was changed to hold receive data until the line discipline could accept it.

So in 2.6.17 all the extra data you sent was simply discarded and flushing the ldisc buffers cleared all of the receive data. Starting with 2.6.18, flushing the ldisc buffers just allowed the intermediate buffering to start feeding more data to the ldisc. This results in the receive data you see after a TCFLSH.

Starting with 2.6.22 TCFLSH is processed by the intermediate buffering as well as the ldisc to eliminate any remaining receive data in the intermediate buffering.

--
Paul Fulghum
Microgate Systems, Ltd