timeout for direct mounts?
I can't seem to figure out where to specify the timeout for a direct mount. It doesn't seem to work as an option in auto.master or auto.direct.
Anyone know?
Signature · 1 line
Chris Walker -- [email protected]
Ian Kent
maintainerQuoted 3 lines · Chris Walker
I can't seem to figure out where to specify the timeout for a direct mount. It doesn't seem to work as an option in auto.master or auto.direct.
Did you find out what this problem was?
Ian
I didn't. I'm just not sure where to put the --timeout arg to get to work for direct mounts.
From raven [10/06 02:20]:
Quoted 10 lines · Chris Walker
Quoted 3 lines
I can't seem to figure out where to specify the timeout for a direct mount. It doesn't seem to work as an option in auto.master or auto.direct.
Did you find out what this problem was?
Ian
Signature · 1 line
Chris Walker -- [email protected]
Ian Kent
maintainerQuoted 2 lines · Chris Walker
I didn't. I'm just not sure where to put the --timeout arg to get to work for direct mounts.
It's the same as for indirect map entries.
At the end of the line in the master map entry.
/- auto.direct --timeout=180
The question gets more interesting if you have multiple direct map entries.
Quoted 13 lines
From raven [10/06 02:20]:
Quoted 10 lines · Chris Walker
Quoted 3 lines
I can't seem to figure out where to specify the timeout for a direct mount. It doesn't seem to work as an option in auto.master or auto.direct.
Did you find out what this problem was?
Ian