lpfc 8.3.0 : Fix issue with assumed IEB support
Subsystems (2)
PATCH 7/14 lpfc 8.3.0 : Fix issue with assumed IEB support
lpfc 8.3.0 : Fix issue with assumed Interrupt Enable Block support
The phba hbq_get address was setup before the HBA reported support for Interrupt Enable Block (INB). This caused loopback tests to fail after all HBQs had been used once. Moved setting of hba_get until after config port mailbox command completes.
Signed-off-by James Smart <[email protected]>
---
drivers/scsi/lpfc/lpfc_mbox.c | 11 +++-------- drivers/scsi/lpfc/lpfc_sli.c | 3 +++ 2 files changed, 6 insertions(+), 8 deletions(-)
drivers/scsi/lpfc/lpfc_mbox.c +3 -8
@@ -1198,16 +1198,11 @@ lpfc_config_port(struct lpfc_hba *phba, LPFC_MBOXQ_t *pmb) sizeof(*phba->host_gp)); } -/* Setup Port Group ring pointer */ -if (phba->sli3_options &LPFC_SLI3_INB_ENABLED ) { - pgp_offset = offsetof(struct lpfc_sli2_slim , - mbx.us.s3_inb_pgp.port); - phba->hbq_get = phba->mbox->us.s3_inb_pgp.hbq_get; - }else if (phba->sli_rev ==3 ) { +/* Setup Port Group offset */ +if (phba->sli_rev ==3 ) pgp_offset = offsetof(struct lpfc_sli2_slim , mbx.us.s3_pgp.port); - phba->hbq_get = phba->mbox->us.s3_pgp.hbq_get; - }else +else pgp_offset = offsetof(struct lpfc_sli2_slim, mbx.us.s2.port); pdma_addr = phba->slim2p.phys + pgp_offset; phba->pcb->pgpAddrHigh =putPaddrHigh (pdma_addr);
drivers/scsi/lpfc/lpfc_sli.c +3 -0
@@ -3144,17 +3144,20 @@ lpfc_sli_config_port(struct lpfc_hba *phba, int sli_mode) phba->sli3_options |=LPFC_SLI3_CRP_ENABLED ;if (pmb->mb.un.varCfgPort.ginb) { phba->sli3_options |=LPFC_SLI3_INB_ENABLED ; + phba->hbq_get = phba->mbox->us.s3_inb_pgp.hbq_get; phba->port_gp = phba->mbox->us.s3_inb_pgp.port; phba->inb_ha_copy = &phba->mbox->us.s3_inb_pgp.ha_copy; phba->inb_counter = &phba->mbox->us.s3_inb_pgp.counter; phba->inb_last_counter = phba->mbox->us.s3_inb_pgp.counter; }else { + phba->hbq_get = phba->mbox->us.s3_pgp.hbq_get; phba->port_gp = phba->mbox->us.s3_pgp.port; phba->inb_ha_copy =NULL ; phba->inb_counter =NULL ; } }else { + phba->hbq_get =NULL ; phba->port_gp = phba->mbox->us.s2.port; phba->inb_ha_copy =NULL ; phba->inb_counter =NULL ;