Skip to contentSkip to conversation

Don't use ttyS* serial device name for board specific PNX8XXX UART serial

PATCH New Ihar Hrachyshka 1 participant 1 message Jan 14, 2009 MIPS

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 Don't use ttyS* serial device name for board specific PNX8XXX UART serial

Don't use ttyS* serial device name for board specific PNX8XXX UART serial. Rather create ttySA* to reflect that the driver uses device with major:minor numbers for SA1100 serial driver.

---
 drivers/serial/pnx8xxx_uart.c |    8 ++++----
 1 files changed, 4 insertions(+), 4 deletions(-)
drivers/serial/pnx8xxx_uart.c +4 -4
index 22e30d2..6785ee9 100644
@@ -636,7 +636,7 @@ static struct uart_ops pnx8xxx_pops = {
 /*
  * Setup the PNX8XXX serial ports.
  *
- * Note also that we support "console=ttySx" where "x" is either 0 or 1.
+ * Note also that we support "console=ttySAx" where "x" is either 0 or 1.
  */
 static void __init pnx8xxx_init_ports(void)
 {
@@ -728,7 +728,7 @@ pnx8xxx_console_setup(struct console *co, char *options)
 
 static struct uart_driver pnx8xxx_reg;
 static struct console pnx8xxx_console = {
-	.name		= "ttyS",
+	.name		= "ttySA",
 	.write		= pnx8xxx_console_write,
 	.device		= uart_console_device,
 	.setup		= pnx8xxx_console_setup,
@@ -752,8 +752,8 @@ console_initcall(pnx8xxx_rs_console_init);
 
 static struct uart_driver pnx8xxx_reg = {
 	.owner			= THIS_MODULE,
-	.driver_name		= "ttyS",
-	.dev_name		= "ttyS",
+	.driver_name		= "ttySA",
+	.dev_name		= "ttySA",
 	.major			= SERIAL_PNX8XXX_MAJOR,
 	.minor			= MINOR_START,
 	.nr			= NR_PORTS,
Signature · 1 line
1.5.6.3