: Resend new Blackfin on-chip SIR IrDA driver (v4)
PATCH 1/1 : Resend new Blackfin on-chip SIR IrDA driver (v4)
From: Graff Yang <[email protected]>
v3-v4: Revised according suggestions from Mike Frysinger
1. Use dev_warn(&pdev->dev, ...) in bfin_sir_probe()
2. Add sanity check for pdev->id
Signed-off-by Graff Yang <[email protected]>
--- drivers/net/irda/Kconfig | 45 +++ drivers/net/irda/Makefile | 1 + drivers/net/irda/bfin_sir.c | 820 +++++++++++++++++++++++++++++++++++++++++++ drivers/net/irda/bfin_sir.h | 148 ++++++++ 4 files changed, 1014 insertions(+), 0 deletions(-) create mode 100644 drivers/net/irda/bfin_sir.c create mode 100644 drivers/net/irda/bfin_sir.h
drivers/net/irda/Kconfig +45 -0
@@ -17,6 +17,51 @@ config IRTTY_SIR If unsure, say Y. +config BFIN_SIR + tristate "Blackfin SIR on UART" + depends on BLACKFIN && IRDA + default n + help + Say Y here if your want to enable SIR function on Blackfin UART + devices. + + To activate this driver you can start irattach like: + "irattach irda0 -s" + + Saying M, it will be built as a module named bfin_sir. + + Note that you need to turn off one of the serial drivers for SIR + to use that UART. + +config BFIN_SIR0 + bool "Blackfin SIR on UART0" + depends on BFIN_SIR && !SERIAL_BFIN_UART0 + +config BFIN_SIR1 + bool "Blackfin SIR on UART1" + depends on BFIN_SIR && !SERIAL_BFIN_UART1 && (!BF531 && !BF532 && !BF533 && !BF561) + +config BFIN_SIR2 + bool "Blackfin SIR on UART2" + depends on BFIN_SIR && !SERIAL_BFIN_UART2 && (BF54x || BF538 || BF539) + +config BFIN_SIR3 + bool "Blackfin SIR on UART3" + depends on BFIN_SIR && !SERIAL_BFIN_UART3 && (BF54x) + +choice + prompt "SIR Mode" + depends on BFIN_SIR + default SIR_BFIN_DMA + +config SIR_BFIN_DMA + bool "DMA mode" + depends on !DMA_UNCACHED_NONE + +config SIR_BFIN_PIO + bool "PIO mode" +endchoice + comment "Dongle support" config DONGLE
drivers/net/irda/Makefile +1 -0
@@ -21,6 +21,7 @@ obj-$(CONFIG_MCS_FIR) += mcs7780.o obj-$(CONFIG_AU1000_FIR) += au1k_ir.o # SIR drivers obj-$(CONFIG_IRTTY_SIR) += irtty-sir.o sir-dev.o +obj-$(CONFIG_BFIN_SIR) += bfin_sir.o # dongle drivers for SIR drivers obj-$(CONFIG_ESI_DONGLE) += esi-sir.o obj-$(CONFIG_TEKRAM_DONGLE) += tekram-sir.o
drivers/net/irda/bfin_sir.c new file +820 -0
820 lines not on this page · raw message
drivers/net/irda/bfin_sir.h new file +148 -0
148 lines not on this page · raw message
Signature · 1 line
1.6.1