Skip to contentSkip to conversation

mac80211: move ieee80211_enable_ht function to mlme.c

PATCH New Johannes Berg 1 participant 1 message Mar 30, 2009 mac80211

lore
Share & tools
lore

Johannes Berg

author maintainer
#0 lore raw

PATCH 1/1 mac80211: move ieee80211_enable_ht function to mlme.c

It really belongs into that file since it is only relevant for managed mode. Move 1:1, not even whitespace changes, but make it static and remove from header file.

---
 net/mac80211/ht.c          |   83 ---------------------------------------------
 net/mac80211/ieee80211_i.h |    3 -
 net/mac80211/mlme.c        |   83 +++++++++++++++++++++++++++++++++++++++++++++
 3 files changed, 83 insertions(+), 86 deletions(-)
net/mac80211/ht.c +0 -83
@@ -83,89 +83,6 @@ void ieee80211_ht_cap_ie_to_sta_ht_cap(s
 		ht_cap->mcs.rx_mask[32/8] |= 1;
 }
 
-/*
- * ieee80211_enable_ht should be called only after the operating band
- * has been determined as ht configuration depends on the hw's
- * HT abilities for a specific band.
- */
-u32 ieee80211_enable_ht(struct ieee80211_sub_if_data *sdata,
-			struct ieee80211_ht_info *hti,
-			u16 ap_ht_cap_flags)
-{
-	struct ieee80211_local *local = sdata->local;
-	struct ieee80211_supported_band *sband;
-	struct ieee80211_if_managed *ifmgd = &sdata->u.mgd;
-	struct ieee80211_bss_ht_conf ht;
-	struct sta_info *sta;
-	u32 changed = 0;
-	bool enable_ht = true, ht_changed;
-	enum nl80211_channel_type channel_type = NL80211_CHAN_NO_HT;
-
-	sband = local->hw.wiphy->bands[local->hw.conf.channel->band];
-
-	memset(&ht, 0, sizeof(ht));
-
-	/* HT is not supported */
-	if (!sband->ht_cap.ht_supported)
-		enable_ht = false;
-
-	/* check that channel matches the right operating channel */
-	if (local->hw.conf.channel->center_freq !=
-	    ieee80211_channel_to_frequency(hti->control_chan))
-		enable_ht = false;
-
-	if (enable_ht) {
-		channel_type = NL80211_CHAN_HT20;
-
-		if (!(ap_ht_cap_flags & IEEE80211_HT_CAP_40MHZ_INTOLERANT) &&
-		    (sband->ht_cap.cap & IEEE80211_HT_CAP_SUP_WIDTH_20_40) &&
-		    (hti->ht_param & IEEE80211_HT_PARAM_CHAN_WIDTH_ANY)) {
-			switch(hti->ht_param & IEEE80211_HT_PARAM_CHA_SEC_OFFSET) {
-			case IEEE80211_HT_PARAM_CHA_SEC_ABOVE:
-				channel_type = NL80211_CHAN_HT40PLUS;
-				break;
-			case IEEE80211_HT_PARAM_CHA_SEC_BELOW:
-				channel_type = NL80211_CHAN_HT40MINUS;
-				break;
-			}
-		}
-	}
-
-	ht_changed = conf_is_ht(&local->hw.conf) != enable_ht ||
-		     channel_type != local->hw.conf.channel_type;
-
-	local->oper_channel_type = channel_type;
-
-	if (ht_changed) {
-                /* channel_type change automatically detected */
-		ieee80211_hw_config(local, 0);
-
-		rcu_read_lock();
-
-		sta = sta_info_get(local, ifmgd->bssid);
-		if (sta)
-			rate_control_rate_update(local, sband, sta,
-						 IEEE80211_RC_HT_CHANGED);
-
-		rcu_read_unlock();
-
-        }
-
-	/* disable HT */
-	if (!enable_ht)
-		return 0;
-
-	ht.operation_mode = le16_to_cpu(hti->operation_mode);
-
-	/* if bss configuration changed store the new one */
-	if (memcmp(&sdata->vif.bss_conf.ht, &ht, sizeof(ht))) {
-		changed |= BSS_CHANGED_HT;
-		sdata->vif.bss_conf.ht = ht;
-	}
-
-	return changed;
-}
-
 void ieee80211_sta_tear_down_BA_sessions(struct sta_info *sta)
 {
 	int i;
net/mac80211/ieee80211_i.h +0 -3
@@ -1002,9 +1002,6 @@ int ieee80211_subif_start_xmit(struct sk
 void ieee80211_ht_cap_ie_to_sta_ht_cap(struct ieee80211_supported_band *sband,
 				       struct ieee80211_ht_cap *ht_cap_ie,
 				       struct ieee80211_sta_ht_cap *ht_cap);
-u32 ieee80211_enable_ht(struct ieee80211_sub_if_data *sdata,
-			struct ieee80211_ht_info *hti,
-			u16 ap_ht_cap_flags);
 void ieee80211_send_bar(struct ieee80211_sub_if_data *sdata, u8 *ra, u16 tid, u16 ssn);
 void ieee80211_send_delba(struct ieee80211_sub_if_data *sdata,
 			  const u8 *da, u16 tid,
net/mac80211/mlme.c +83 -0

89 lines not on this page · raw message