powerpc/4xx: Sequoia: Enable NAND support
Subsystems (2)
PATCH 1/1 powerpc/4xx: Sequoia: Enable NAND support
Now that the 4xx NAND driver is available again in arch/powerpc, let's enable it on Sequoia. This patch also disables the early debug messages (CONFIG_PPC_EARLY_DEBUG) in the Sequoia defconfig.
Signed-off-by Stefan Roese <[email protected]>
--- arch/powerpc/boot/dts/sequoia.dts | 22 ++++++ arch/powerpc/configs/44x/sequoia_defconfig | 109 ++++++++++++++++++---------- 2 files changed, 94 insertions(+), 37 deletions(-)
arch/powerpc/boot/dts/sequoia.dts +22 -0
@@ -199,6 +199,28 @@ }; }; + ndfc@3,0 { + compatible = "ibm,ndfc"; + reg = <0x00000003 0x00000000 0x00002000>; + ccr = <0x00001000>; + bank-settings = <0x80002222>; + #address-cells = <1>; + #size-cells = <1>; + + nand { + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "u-boot"; + reg = <0x00000000 0x00084000>; + }; + partition@84000 { + label = "user"; + reg = <0x00000000 0x01f7c000>; + }; + }; + }; }; UART0: serial@ef600300 {
arch/powerpc/configs/44x/sequoia_defconfig +72 -37
368 lines not on this page · raw message
Signature · 1 line
1.6.2.2