ppc4xx: Disable POST memory test on NAND-booting Kilauea
PATCH 1/1 ppc4xx: Disable POST memory test on NAND-booting Kilauea
Don't run the memory POST on the NAND-booting version. It will overwrite part of the U-Boot image which is already loaded from NAND to SDRAM. We were just lucky that it booted at all with this SDRAM test enabled.
Signed-off-by Stefan Roese <[email protected]>
--- include/configs/kilauea.h | 13 ++++++++++++- 1 files changed, 12 insertions(+), 1 deletions(-)
include/configs/kilauea.h +12 -1
@@ -430,12 +430,23 @@#define CONFIG_CMD_PCI #define CONFIG_CMD_SNTP +/* +* Don't run the memory POST on the NAND-booting version. It will +* overwrite part of the U-Boot image which is already loaded from NAND +* to SDRAM. +*/ +#if defined(CONFIG_NAND_U_BOOT ) +#define CONFIG_SYS_POST_MEMORY_ON 0 +#else +#define CONFIG_SYS_POST_MEMORY_ON CONFIG_SYS_POST_MEMORY +#endif +/* POST support */ #define CONFIG_POST (CONFIG_SYS_POST_CACHE | \ CONFIG_SYS_POST_CPU | \ CONFIG_SYS_POST_ETHER | \ CONFIG_SYS_POST_I2C | \ - CONFIG_SYS_POST_MEMORY | \ + CONFIG_SYS_POST_MEMORY_ON | \ CONFIG_SYS_POST_UART)/* Define here the base-addresses of the UARTs to test in POST */
Signature · 1 line
1.6.2.3