cold boot failing on PPC 750
We ported u-boot on a custom designed hardware with power pc 750 and a cpc700 bridge. We encounter a strange problem ;The code runs fine throwing the boot messages of u-boot only when run for the first time after flashing thru a BDM debugger under the BDM debugger control. when we try to HRESET (cold start) the board ,we do not see it throwing any messages on the serial console.Henceforth when we try to run the same code under BDM control it doesn't run correctly and hangs in a loop. Kindly advise.
Regards
Satish Gopalam
Quoted 4 lines · In message <[email protected]> you wrote:
We ported u-boot on a custom designed hardware with power pc 750 and a cpc700 bridge. We encounter a strange problem ;The code runs fine throwing the boot messages of u-boot only when run for the first time after flashing thru a BDM debugger under the BDM debugger control.
To be precise... this is not possible. The 750 has no BDM debug port. AFAIK BDM is being used only on the MPC5xx/8xx families.
Your problem is most probably casued by some init sequence which is present in your debugger init script, but missing in Your U-Boot code.
Quoted 4 lines
when we try to HRESET (cold start) the board ,we do not see it throwing any messages on the serial console.Henceforth when we try to run the same code under BDM control it doesn't run correctly and hangs in a loop. Kindly advise.
"in a loop" ... Which loop? Where exactly? Perhaps you might be so kind as to elucidate.
Best regards,
Wolfgang Denk
Signature · 4 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de Humans do claim a great deal for that particular emotion (love). -- Spock, "The Lights of Zetar", stardate 5725.6