Skip to contentSkip to conversation

2.6.21-git oops

PROBLEM Srihari Vijayaraghavan 2 participants 3 messages May 5, 2007 – May 6, 2007

lore
Share & tools
lore
#0 lore raw

[Sorry to reply to my own email, but I had some good development on this problem]

Quoted 2 lines · --- Srihari Vijayaraghavan

Here's the first one (there a couple following this; the complete dmesg is at the bottom of this email):

It turns out the system is no go with 4 GB of RAM (4 * 1 GB modules): system instability & SATA controller doesn't detect the drives (as I reported to linux-ide:
http://www.mail-archive.com/[email protected]/msg06174.html).

With only 2 GB of RAM (with either pairs), system is very stable (surviving many parallel kernel compiles for over 3 times longer than that of 4 GB), and it detects & works fine with the SATA drives also.

Any advice on getting all of 4 GB to work reliably with SATA also?

Thanks

PS: Here's a dmesg of the all stably working 2 GB system, & the oopsy one with 4 GB.

Send instant messages to your online friends http://au.messenger.yahoo.com

#1 lore raw

Hi Srihari,

Quoted 16 lines · Srihari Vijayaraghavan

[Sorry to reply to my own email, but I had some good development on this problem]

Quoted 2 lines · --- Srihari Vijayaraghavan

Here's the first one (there a couple following this; the complete dmesg is at the bottom of this email):

It turns out the system is no go with 4 GB of RAM (4 * 1 GB modules): system instability & SATA controller doesn't detect the drives (as I reported to linux-ide:
http://www.mail-archive.com/[email protected]/msg06174.html).

With only 2 GB of RAM (with either pairs), system is very stable (surviving many parallel kernel compiles for over 3 times longer than that of 4 GB), and it detects & works fine with the SATA drives also.

Quoted 7 lines

Any advice on getting all of 4 GB to work reliably with SATA also?

Thanks

PS: Here's a dmesg of the all stably working 2 GB system, & the oopsy one with 4 GB.

This looks like a bad RAM problem too me. Check the RAM memory
http://www.memtest.org/

(Removed from the list of known regressions
http://kernelnewbies.org/known_regressions)

Regards,
Michal

Signature · 3 lines
Michal K. K. Piotrowski
Kernel Monkeys
(http://kernel.wikidot.com/start)
#2 lore raw
Quoted 1 line · --- Michal Piotrowski

Hi Srihari,

Hello Michal,

[...]

Quoted 13 lines
Quoted 1 line

It turns out the system is no go with 4 GB of RAM (4 * 1 GB modules):

system

Quoted 5 lines

instability & SATA controller doesn't detect the drives (as I reported to linux-ide:
http://www.mail-archive.com/[email protected]/msg06174.html).

With only 2 GB of RAM (with either pairs), system is very stable

(surviving

Quoted 1 line

many parallel kernel compiles for over 3 times longer than that of 4 GB),

and

Quoted 3 lines

it detects & works fine with the SATA drives also.

Any advice on getting all of 4 GB to work reliably with SATA also?

[...]

Quoted 2 lines

This looks like a bad RAM problem too me. Check the RAM memory
http://www.memtest.org/

I disagree it to be a bad RAM problem (please read on). But agree undeniably to run the memtest a little later on (FWIW, Linux & kernel compile tests are indeed my test case to prove the stability of the machine).

(I can assure no component is overclocked; I prefer stability over performance with instability :-). Power & ventilation seem quite adequate, but nonetheless I haven't eliminated yet - for stability, not for SATA detection.)

Assuming it's indeed a bad RAM (which I don't sincerely/logically believe), may I ask then how would you explain:
1. SATA drives aren't even detected with 4 GB of RAM
2. Or the system working reliably with _both_ pairs of memory modules individually, ie when limited to 2 GB only, when kernel compile torture test succeeds for many hours with no problems (repeated the test case for a few times also to prove the memory modules are themselves in very good condition), while crashing in a few minutes reliably/repeatably under 4 GB

Logically speaking, if I were to hypothesize what the problem might be:
1. mother board is no go with 4 GB of RAM (for both system stability & SATA drives detection) - Escalated it to Asus to confirm.
2. (my dearest) Linux kernel doesn't configure/program things in this board to work reliably.
3. Sadly I don't know yet if there is a boot parameter for Linux or a configuration setting in BIOS to make things work both reliably & completely.

(I vaguely remember in a thread a few weeks/months ago in LKML on AMD64/Nvidia chipset combo, using SW IOMMU lead to improved stability on machines with large amount of RAM?? Or was that limiting the RAM to under 4 GB that helped?? I could be completely wrong here.)

Quoted 2 lines

(Removed from the list of known regressions
http://kernelnewbies.org/known_regressions)

(Initially I believed it to be a regression wrongly, but it was not. Since then I've eliminated a few variables in my tests. Sorry for my misunderstanding.)

Thank you for your help so far.

Hari

Send instant messages to your online friends http://au.messenger.yahoo.com