No OMAP PM code on the PM branch???
I'm looking through Kevin's PM branch, and I've done a quick-port of 2.6.30-rc1 to Logic's OMAP3530 LV SOM starting with the rk21 board code, and "echo mem > /sys/power/state" does nothing. Worse,
"cat /sys/power/state" doesn't show anything.
This is due to no code calling suspend_set_ops() which used to be in arch/arm/mach-omap2/pm34xx.c - this isn't in either Tony or Kevin's current tree.
1) Am I way off base (i.e. am I missing something obvious here)?
Signature · 1 line
Peter Barada <[email protected]>
Peter,
Quoted 11 lines · Peter Barada
I'm looking through Kevin's PM branch, and I've done a quick-port of 2.6.30-rc1 to Logic's OMAP3530 LV SOM starting with the rk21 board code, and "echo mem >
/sys/power/state" does nothing. Worse,
"cat/sys/power/state" doesn't show anything.This is due to no code calling
suspend_set_ops()which used to be inarch/arm/mach-omap2/pm34xx.c- this isn't in either Tony or Kevin's current tree.1) Am I way off base (i.e. am I missing something obvious here)?
check out Kevin's email "Re: n800 high idle power consumption" on 4/24 on this list. TBH I haven't checked pm branch recently so have no idea if re-basing is complete and if it causes the issue you found.
Thanks,
Eugeny
Quoted 4 lines · Peter Barada
I'm looking through Kevin's PM branch, and I've done a quick-port of 2.6.30-rc1 to Logic's OMAP3530 LV SOM starting with the rk21 board code, and "echo mem >
/sys/power/state" does nothing. Worse,
"cat/sys/power/state" doesn't show anything.
Since 2.6.30, there is no OMAP PM code in linux-omap master branch. The only working PM is now in the PM branch.
I am currently rebasing the PM branch to 2.6.30-rc series and it should be published this week.
Kevin