Fix non-ACPI Timer Interrupt Routing - v3
PATCH RESEND 1/1 Fix non-ACPI Timer Interrupt Routing - v3
***NOTE: Anthony, this needs to replace 0013_fix-non-acpi-timer-interrupt-routing.patch.***
Replicate ACPI irq0->inti2 override in mp table for non-acpi case.
v1 -> v2 adds comment suggested by Ryan.
v2 -> v3 clarifies comment and corrects entry count
Anthony, the old version of this patch needs to be removed and replaced with this version.
Signed-off-by Beth Kon <[email protected]>
---
bios/rombios32.c +14 -0
@@ -1124,7 +1124,11 @@ static void mptable_init(void)putstr (&q,"0.1 " );/* vendor id */ putle32 (&q,0 );/* OEM table ptr */ putle16 (&q,0 );/* OEM table size */ +#ifdef BX_QEMU +putle16 (&q, smp_cpus +17 );/* entry count */ +#else putle16 (&q, smp_cpus +18 );/* entry count */ +#endif putle32 (&q,0xfee00000 );/* local APIC addr */ putle16 (&q,0 );/* ext table length */ putb (&q,0 );/* ext table checksum */
@@ -1166,6 +1170,12 @@ static void mptable_init(void)/* irqs */ for (i =0 ; i <16 ; i++) { +#ifdef BX_QEMU +/* One entry per ioapic interrupt destination. Destination 2 is covered +by irq0->inti2 override (i == 0). Source IRQ 2 is unused */ +if (i ==2 ) +continue ; +#endif putb (&q,3 );/* entry type = I/O interrupt */ putb (&q,0 );/* interrupt type = vectored interrupt */ putb (&q,0 );/* flags: po=0, el=0 */
@@ -1173,7 +1183,11 @@ static void mptable_init(void)putb (&q,0 );/* source bus ID = ISA */ putb (&q, i);/* source bus IRQ */ putb (&q, ioapic_id);/* dest I/O APIC ID */ +#ifdef BX_QEMU +putb (&q, i ==0 ?2 : i);/* dest I/O APIC interrupt in */ +#else putb (&q, i);/* dest I/O APIC interrupt in */ +#endif }/* patch length */ len = q - mp_config_table;