Skip to contentSkip to conversation

ath9k: Update rate control for 11NA HT40 mode

PATCH New Vasanthakumar Thiagarajan 1 participant 3 messages Jul 29, 2009 Qualcomm Atheros ATH9K wireless driver

lore
Share & tools
lore
#0 lore raw

PATCH 1/3 ath9k: Update rate control for 11NA HT40 mode

Now the lowest rate in 11na ht40 mode is 13.5Mbps this shortens the range when compared to 11na ht20 mode where the lowest rate is 6.5Mbps. To improve the range, make 6.5Mbps as the lowest rate in 11na ht40 mode, this improves the range by approximately 2dB. 11ng ht40 does not have this issue as it also has basic rates (1, 2, 5.5 and 11).

---
 drivers/net/wireless/ath/ath9k/rc.c |    4 +---
 1 files changed, 1 insertions(+), 3 deletions(-)
drivers/net/wireless/ath/ath9k/rc.c +1 -3
index a07efa2..59ad47c 100644
@@ -44,7 +44,7 @@ static const struct ath_rate_table ar5416_11na_ratetable = {
 		{ VALID, VALID, WLAN_RC_PHY_OFDM, 54000, /* 54 Mb */
 			29300, 0x0c, 0x00, 108,
 			4,  7, 7, 7, 7, 0 },
-		{ VALID_20, VALID_20, WLAN_RC_PHY_HT_20_SS, 6500, /* 6.5 Mb */
+		{ VALID_2040, VALID_2040, WLAN_RC_PHY_HT_20_SS, 6500, /* 6.5 Mb */
 			6400, 0x80, 0x00, 0,
 			0, 8, 24, 8, 24, 3216 },
 		{ VALID_20, VALID_20, WLAN_RC_PHY_HT_20_SS, 13000, /* 13 Mb */
@@ -463,8 +463,6 @@ static int ath_rc_valid_phyrate(u32 phy, u32 capflag, int ignore_cw)
 	if (!ignore_cw && WLAN_RC_PHY_HT(phy))
 		if (WLAN_RC_PHY_40(phy) && !(capflag & WLAN_RC_40_FLAG))
 			return 0;
-		if (!WLAN_RC_PHY_40(phy) && (capflag & WLAN_RC_40_FLAG))
-			return 0;
 	return 1;
 }
 
Signature · 1 line
1.5.5.1
#1 lore raw

PATCH 2/3 ath9k: Maintain monotonicity of PER while going across different phy

Monotonicity of packet error rate should be kept when moving from one phy to another (legacy to ht, ht single stream to dual, etc). Current code skips updating per for other phys.

---
 drivers/net/wireless/ath/ath9k/rc.c |    3 ---
 1 files changed, 0 insertions(+), 3 deletions(-)
drivers/net/wireless/ath/ath9k/rc.c +0 -3
index 59ad47c..16a2717 100644
@@ -1041,9 +1041,6 @@ static void ath_rc_update_ht(struct ath_softc *sc,
 	/* Monotonicity is kept only for rates below the current rate. */
 	if (ath_rc_priv->per[tx_rate] < last_per) {
 		for (rate = tx_rate - 1; rate >= 0; rate--) {
-			if (rate_table->info[rate].phy !=
-			    rate_table->info[tx_rate].phy)
-				break;
 
 			if (ath_rc_priv->per[rate] >
 			    ath_rc_priv->per[rate+1]) {
Signature · 1 line
1.5.5.1
#2 lore raw

PATCH 3/3 ath9k: Remove unused ath9k_hw_intrget()

---
 drivers/net/wireless/ath/ath9k/hw.c |    5 -----
 drivers/net/wireless/ath/ath9k/hw.h |    1 -
 2 files changed, 0 insertions(+), 6 deletions(-)
drivers/net/wireless/ath/ath9k/hw.c +0 -5
index 431854c..7a0a6ae 100644
@@ -3152,11 +3152,6 @@ bool ath9k_hw_getisr(struct ath_hw *ah, enum ath9k_int *masked)
 	return true;
 }
 
-enum ath9k_int ath9k_hw_intrget(struct ath_hw *ah)
-{
-	return ah->mask_reg;
-}
-
 enum ath9k_int ath9k_hw_set_interrupts(struct ath_hw *ah, enum ath9k_int ints)
 {
 	u32 omask = ah->mask_reg;
drivers/net/wireless/ath/ath9k/hw.h +0 -1
index 2e196df..93a8930 100644
@@ -612,7 +612,6 @@ void ath9k_hw_configpcipowersave(struct ath_hw *ah, int restore);
 /* Interrupt Handling */
 bool ath9k_hw_intrpend(struct ath_hw *ah);
 bool ath9k_hw_getisr(struct ath_hw *ah, enum ath9k_int *masked);
-enum ath9k_int ath9k_hw_intrget(struct ath_hw *ah);
 enum ath9k_int ath9k_hw_set_interrupts(struct ath_hw *ah, enum ath9k_int ints);
 
 void ath9k_hw_btcoex_enable(struct ath_hw *ah);
Signature · 1 line
1.5.5.1