Skip to contentSkip to conversation

PCIe device driver question

DISCUSSION Sanka Piyaratna 2 participants 2 messages Jul 30, 2008

lore
Share & tools
lore
#0 lore raw

Hi,

I am currently developing a PCIe data capture card hardware and the device drivers to drive this. I have implemented DMA on the data capture and the scatter-gather DMA is implemented in the hardware. I am testing this in an X86_64 architecture machine with 4 GB of RAM. I am able to successfully dma data into any memory (dma) address > 0x0000_0001_0000_0000. However, my problem is to dma data to any address less than this. When I try to DMA data to an address less than 0x0000_0001_0000_0000, the hardware device hangs indicating that the address does not exist.

I have implemented the DMA mask to be full 64 bit and my hardware is capable of transfering data to any address < 8TB. I am using kernel version 2.6.23.11.

Could you please let me know what I might be doing wrong?

Thanks and regards,

Sanka

Find a better answer, faster with the new Yahoo!7 Search. www.yahoo7.com.au/search

#1 lore raw
Quoted 11 lines · On Wed, 30 Jul 2008 09:00:58 -0700 (PDT) Sanka Piyaratna <[email protected]>…

Hi,

I am currently developing a PCIe data capture card hardware and the device drivers to drive this. I have implemented DMA on the data capture and the scatter-gather DMA is implemented in the hardware. I am testing this in an X86_64 architecture machine with 4 GB of RAM. I am able to successfully dma data into any memory (dma) address > 0x0000_0001_0000_0000. However, my problem is to dma data to any address less than this. When I try to DMA data to an address less than 0x0000_0001_0000_0000, the hardware device hangs indicating that the address does not exist.

Assuming the failures are in the range 640K-1MB then I would imagine your bridge doesn't permit transfers via DMA to the ISA hole.