Skip to contentSkip to conversation

kworld studio terminator (saa7134) noise on capture

DISCUSSION hermann pitton 1 participant 1 message Oct 20, 2009 1 message not in the archive Media (V4L/DVB)

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw

Hi Asko, folks,

currently I don't have time for GNU/Linux and must care for family members. Please try to get help by other list members.

Am Dienstag, den 20.10.2009, 17:41 +0300 schrieb Asko Tamm:

Quoted 33 lines

Hi Hermann,

I found you have dealt with saa7134 driver noise and LNA issues
(http://patchwork.kernel.org/patch/24348/). I hope you can direct me a bit further on the issue i'm having with Kworld studio terminator (pci)..

I am capturing old VHS from composite input. The strange thing is, that after first capture (mencoder interrupted with ctrl-c), the input becomes noisy. After unloading and reloading the saa7134* modules, i have one chance to capture cleanly again.

Also, sometimes (1 of about every 10 captures) i get a clean capture without reloading the module.

Could it be some LNA initialization issue on the noisy picture? How to debug this?

some screenshots:
http://84.50.124.61/snap_noise.png
http://84.50.124.61/snap_nonoise.png

captures are from same tape.

It seems to happen only in high resolution (eg 720x576), did notice
this in 352x576.
I am capturing with mencoder like this:
"mencoder -tv \
driver=v4l2:width=720:height=576:input=1:norm=pal:fps=25:amode=1:alsa=yes:immediatemode=0:adevice=hw.1,0:audiorate=32000 \
tv:// -ovc raw -oac pcm \
-o $1_raw.mpg"

Quoted 7 lines

i load the module with these parameters:
options saa7134 card=65 tuner=54

Thanks!
--
asko

That must be something else.

LNAs are only involved in tuner RF input amplification for what I know so far.

User noticeable symptoms of missing LNA support, as reported so far, are a horizontally moving black bar after switching channels, missing vsync, or humming noise on analog audio and a sometimes flashing picture.

I admit that your both pictures look exactly like the tda8275 is driven with one more passive splitter too much into more worse reception conditions, but don't have a rhyme on it, why it should work for first usage only.

Cheers,
Hermann