tg3: Add 50610M phy ID for 5785

PATCH In review Matt Carlson 1 participant 1 message Nov 3, 2009

Subsystems (2)

Networking Network drivers

lore

Share & tools

lore

Matt Carlson

author

2009-11-03 01:33 UTC #0 lore raw

PATCH 13/20 tg3: Add 50610M phy ID for 5785

This patch adds the 50610M phy ID for 5785.

Signed-off-by Matt Carlson <[email protected]>

Reviewed-by Michael Chan <[email protected]>

---
 drivers/net/tg3.c |    2 ++
 drivers/net/tg3.h |    1 +
 2 files changed, 3 insertions(+), 0 deletions(-)

drivers/net/tg3.c +2 -0

index 7bebb47..0aecd07 100644
@@ -940,6 +940,7 @@ static void tg3_mdio_config_5785(struct tg3 *tp)
 	phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
 	switch (phydev->drv->phy_id & phydev->drv->phy_id_mask) {
 	case TG3_PHY_ID_BCM50610:
+	case TG3_PHY_ID_BCM50610M:
 		val = MAC_PHYCFG2_50610_LED_MODES;
 		break;
 	case TG3_PHY_ID_BCMAC131:

@@ -1098,6 +1099,7 @@ static int tg3_mdio_init(struct tg3 *tp)
 		phydev->interface = PHY_INTERFACE_MODE_GMII;
 		break;
 	case TG3_PHY_ID_BCM50610:
+	case TG3_PHY_ID_BCM50610M:
 		if (tp->tg3_flags3 & TG3_FLG3_RGMII_STD_IBND_DISABLE)
 			phydev->dev_flags |= PHY_BRCM_STD_IBND_DISABLE;
 		if (tp->tg3_flags3 & TG3_FLG3_RGMII_EXT_IBND_RX_EN)

drivers/net/tg3.h +1 -0

index 9999345..d770da1 100644
@@ -2864,6 +2864,7 @@ struct tg3 {
 #define PHY_REV_BCM5401_C0		0x6
 #define PHY_REV_BCM5411_X0		0x1 /* Found on Netgear GA302T */
 #define TG3_PHY_ID_BCM50610		0x143bd60
+#define TG3_PHY_ID_BCM50610M	0x143bd70
 #define TG3_PHY_ID_BCMAC131		0x143bc70
 #define TG3_PHY_ID_RTL8211C		0x001cc910
 #define TG3_PHY_ID_RTL8201E		0x00008200

Signature · 1 line

1.6.4.4