Skip to contentSkip to conversation

tg3 / broadcom: Refine AC131 APD support

PATCH In review Matt Carlson 1 participant 1 message Nov 3, 2009

Subsystems (4)
Networking Network drivers Ethernet PHY Broadcom Ethernet PHY drivers
lore
Share & tools
lore

Matt Carlson

author
#0 lore raw

PATCH 16/20 tg3 / broadcom: Refine AC131 APD support

Auto power-down (APD) support is a power-saving feature. It should be selectively enabled since it might expose MAC bugs. This patch changes the code to enable APD only if the PHY_BRCM_AUTO_PWRDWN_ENABLE flag is set. The tg3 driver was changed to set this bit.

Signed-off-by Matt Carlson <[email protected]>
Reviewed-by Michael Chan <[email protected]>
---
 drivers/net/phy/broadcom.c |    8 +++++---
 drivers/net/tg3.c          |    1 +
 2 files changed, 6 insertions(+), 3 deletions(-)
drivers/net/phy/broadcom.c +5 -3
index 5d2a2e9..bddf4a4 100644
@@ -561,9 +561,11 @@ static int brcm_fet_config_init(struct phy_device *phydev)
 	if (err < 0)
 		goto done;
 
-	/* Enable auto power down */
-	err = brcm_phy_setbits(phydev, MII_BRCM_FET_SHDW_AUXSTAT2,
-				       MII_BRCM_FET_SHDW_AS2_APDE);
+	if (phydev->dev_flags & PHY_BRCM_AUTO_PWRDWN_ENABLE) {
+		/* Enable auto power down */
+		err = brcm_phy_setbits(phydev, MII_BRCM_FET_SHDW_AUXSTAT2,
+					       MII_BRCM_FET_SHDW_AS2_APDE);
+	}
 
 done:
 	/* Disable shadow register access */
drivers/net/tg3.c +1 -0
index e7128f6..592b5bf 100644
@@ -1114,6 +1114,7 @@ static int tg3_mdio_init(struct tg3 *tp)
 	case TG3_PHY_ID_RTL8201E:
 	case TG3_PHY_ID_BCMAC131:
 		phydev->interface = PHY_INTERFACE_MODE_MII;
+		phydev->dev_flags |= PHY_BRCM_AUTO_PWRDWN_ENABLE;
 		tp->tg3_flags3 |= TG3_FLG3_PHY_IS_FET;
 		break;
 	}
Signature · 1 line
1.6.4.4