Skip to contentSkip to conversation

Question about mac80211 callback

DISCUSSION Larry Finger 2 participants 2 messages Nov 23, 2009

lore
Share & tools
lore
#0 lore raw

Johannes,

I tried to figure this out from the code, but I kept getting lost.

When a computer goes into hibernation, which of the mac80211 callback routines are called, and which ones on the following resume? The problem arises due to the problem in Bug #14267. The routine to check the hardware status of the RFKILL switch is being entered with b43_status() returning 0, thus the hardware switch is not checked. If we do not check for that condition, then we get a machine fault on PPC. I would like to be able to track this problem down. I've already entered two bad patches in this area.

Thanks,

Larry

#1 lore raw

Larry,

Quoted 4 lines

I tried to figure this out from the code, but I kept getting lost.

When a computer goes into hibernation, which of the mac80211 callback routines are called, and which ones on the following resume?

mac80211 will be called via cfg80211, and will run __ieee80211_suspend() which calls a whole bunch of driver things. This is _before_ the driver's suspend() callback runs.

Then, after the driver's resume() callback runs, we go into ieee80211_reconfig() in mac80211.

You can find the interaction with the PM subsystem in net/wireless/sysfs.c.

Quoted 2 lines

The problem arises due to
the problem in Bug #14267.

Wrong bug number?

johannes