Skip to contentSkip to conversation

eLBC NAND: increase bus timeout to maximum

PATCH In review Scott Wood 2 participants 2 messages Nov 13, 2009 – Nov 23, 2009

Subsystems (2)
lore
Share & tools
lore

Scott Wood

author
#0 lore raw

PATCH 1/3 eLBC NAND: increase bus timeout to maximum

When a NAND operation is in progress, all other localbus operations (including NOR flash) will have to wait for access to the bus. However, the NAND operation may take longer to complete than the default timeout. Thus, if NOR is accessed while a NAND operation is in progress, the NAND operation will fail.

---
 drivers/mtd/nand/fsl_elbc_nand.c |    7 +++++++
 1 files changed, 7 insertions(+), 0 deletions(-)
drivers/mtd/nand/fsl_elbc_nand.c +7 -0
index ddd37d2..58db278 100644
@@ -946,6 +946,13 @@ static int __devinit fsl_elbc_ctrl_init(struct fsl_elbc_ctrl *ctrl)
 {
 	struct fsl_lbc_regs __iomem *lbc = ctrl->regs;
 
+	/*
+	 * NAND transactions can tie up the bus for a long time, so set the
+	 * bus timeout to max by clearing LBCR[BMT] (highest base counter
+	 * value) and setting LBCR[BMTPS] to the highest prescaler value.
+	 */
+	clrsetbits_be32(&lbc->lbcr, LBCR_BMT, 15);
+
 	/* clear event registers */
 	setbits32(&lbc->ltesr, LTESR_NAND_MASK);
 	out_be32(&lbc->lteatr, 0);
Signature · 1 line
1.6.4.4
#1 lore raw
Quoted 7 lines · Scott Wood

When a NAND operation is in progress, all other localbus operations (including NOR flash) will have to wait for access to the bus. However, the NAND operation may take longer to complete than the default timeout. Thus, if NOR is accessed while a NAND operation is in progress, the NAND operation will fail.

Taken the patches to my l2-mtd-2.6 tree.

Signature · 2 lines
Best Regards,
Artem Bityutskiy (Артём Битюцкий)