tg3: Reset phy during bringup when using phylib
Subsystems (2)
PATCH 6/9 tg3: Reset phy during bringup when using phylib
The driver puts the phy into low-power mode when it releases the device. If the device were to be reacquired, the phy needs a reset to bring it back to full powered operation. This patch allows phylib-enabled devices to reset the phy.
Signed-off-by Matt Carlson <[email protected]>
Reviewed-by Michael Chan <[email protected]>
Reviewed-by Benjamin Li <[email protected]>
--- drivers/net/tg3.c | 3 +-- 1 files changed, 1 insertions(+), 2 deletions(-)
drivers/net/tg3.c +1 -2
@@ -7595,8 +7595,7 @@ static int tg3_reset_hw(struct tg3 *tp, int reset_phy)tg3_abort_hw (tp,1 ); } -if (reset_phy && - !(tp->tg3_flags3 &TG3_FLG3_USE_PHYLIB )) +if (reset_phy)tg3_phy_reset (tp); err =tg3_chip_reset (tp);
Signature · 1 line
1.6.4.4