ColdFire: Update uart_port_conf in serial driver
PATCH 3/13 ColdFire: Update uart_port_conf in serial driver
Provide proper port passing from serial_init to uart_part_conf.
Signed-off-by TsiChung Liew <[email protected]>
--- drivers/serial/mcfuart.c | 4 ++-- 1 files changed, 2 insertions(+), 2 deletions(-)
drivers/serial/mcfuart.c +2 -2
@@ -34,7 +34,7 @@DECLARE_GLOBAL_DATA_PTR ; -extern void uart_port_conf (void ); +extern void uart_port_conf (int port);int serial_init (void ) {
@@ -43,7 +43,7 @@ int serial_init(void) uart = (volatile uart_t *)(CONFIG_SYS_UART_BASE ); -uart_port_conf (); +uart_port_conf (CONFIG_SYS_UART_PORT );/* write to SICR: SIM2 = uart mode,dcd does not affect rx */ uart->ucr =UART_UCR_RESET_RX ;
Signature · 1 line
1.6.2.5