Skip to contentSkip to conversation

lpfc 8.3.12: Critical fixes

PATCH New James Smart 1 participant 1 message Apr 6, 2010

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 4/7 lpfc 8.3.12: Critical fixes

- Move the code to increase the sg seg count for LP21000 adapters.
- Check pcmd on command completion before dereferencing it.
- Clear queue memory when creating firmware queues to prevent stale entries.
- Replace the use of PAGE_SIZE in many areas that assumed it was always 4k.
- Add an else clause to a conditional that needed to unlock the hba_lock.

---

 lpfc_bsg.c  |    9 ++++-----
 lpfc_bsg.h  |    1 +
 lpfc_els.c  |    2 +-
 lpfc_init.c |   16 +++++++---------
 lpfc_mbox.c |   16 ++++++++--------
 lpfc_sli.c  |   47 +++++++++++++++++++++++++++++++++++------------
 6 files changed, 56 insertions(+), 35 deletions(-)
drivers/scsi/lpfc/lpfc_bsg.c +4 -5
diff -upNr a/drivers/scsi/lpfc/lpfc_bsg.c b/drivers/scsi/lpfc/lpfc_bsg.c
@@ -2590,7 +2590,7 @@ lpfc_bsg_issue_mbox(struct lpfc_hba *phb
 		goto job_done;
 	}
 
-	mb = kzalloc(PAGE_SIZE, GFP_KERNEL);
+	mb = kzalloc(BSG_MBOX_SIZE, GFP_KERNEL);
 	if (!mb) {
 		rc = -ENOMEM;
 		goto job_done;
@@ -2664,13 +2664,12 @@ lpfc_bsg_issue_mbox(struct lpfc_hba *phb
 		rxbmp->virt = lpfc_mbuf_alloc(phba, 0, &rxbmp->phys);
 		INIT_LIST_HEAD(&rxbmp->list);
 		rxbpl = (struct ulp_bde64 *) rxbmp->virt;
-		dmp = diag_cmd_data_alloc(phba, rxbpl, PAGE_SIZE, 0);
+		dmp = diag_cmd_data_alloc(phba, rxbpl, BSG_MBOX_SIZE, 0);
 		if (!dmp) {
 			rc = -ENOMEM;
 			goto job_done;
 		}
 
-		dmp->size = PAGE_SIZE;
 		INIT_LIST_HEAD(&dmp->dma.list);
 		pmb->un.varBIUdiag.un.s2.xmit_bde64.addrHigh =
 			putPaddrHigh(dmp->dma.phys);
@@ -2773,12 +2772,12 @@ lpfc_bsg_mbox_cmd(struct fc_bsg_job *job
 		goto job_error;
 	}
 
-	if (job->request_payload.payload_len != PAGE_SIZE) {
+	if (job->request_payload.payload_len != BSG_MBOX_SIZE) {
 		rc = -EINVAL;
 		goto job_error;
 	}
 
-	if (job->reply_payload.payload_len != PAGE_SIZE) {
+	if (job->reply_payload.payload_len != BSG_MBOX_SIZE) {
 		rc = -EINVAL;
 		goto job_error;
 	}
drivers/scsi/lpfc/lpfc_bsg.h +1 -0
diff -upNr a/drivers/scsi/lpfc/lpfc_bsg.h b/drivers/scsi/lpfc/lpfc_bsg.h
@@ -91,6 +91,7 @@ struct get_mgmt_rev_reply {
 	struct MgmtRevInfo info;
 };
 
+#define BSG_MBOX_SIZE 4096 /* mailbox command plus extended data */
 struct dfc_mbox_req {
 	uint32_t command;
 	uint32_t mbOffset;
drivers/scsi/lpfc/lpfc_els.c +1 -1
diff -upNr a/drivers/scsi/lpfc/lpfc_els.c b/drivers/scsi/lpfc/lpfc_els.c
@@ -5369,7 +5369,7 @@ lpfc_send_els_failure_event(struct lpfc_
 			sizeof(struct lpfc_name));
 		pcmd = (uint32_t *) (((struct lpfc_dmabuf *)
 			cmdiocbp->context2)->virt);
-		lsrjt_event.command = *pcmd;
+		lsrjt_event.command = (pcmd != NULL) ? *pcmd : 0;
 		stat.un.lsRjtError = be32_to_cpu(rspiocbp->iocb.un.ulpWord[4]);
 		lsrjt_event.reason_code = stat.un.b.lsRjtRsnCode;
 		lsrjt_event.explanation = stat.un.b.lsRjtRsnCodeExp;
drivers/scsi/lpfc/lpfc_init.c +7 -9
diff -upNr a/drivers/scsi/lpfc/lpfc_init.c b/drivers/scsi/lpfc/lpfc_init.c
@@ -2599,15 +2599,6 @@ lpfc_create_port(struct lpfc_hba *phba, 
 	init_timer(&vport->els_tmofunc);
 	vport->els_tmofunc.function = lpfc_els_timeout;
 	vport->els_tmofunc.data = (unsigned long)vport;
-	if (phba->pcidev->device == PCI_DEVICE_ID_HORNET) {
-		phba->menlo_flag |= HBA_MENLO_SUPPORT;
-		/* check for menlo minimum sg count */
-		if (phba->cfg_sg_seg_cnt < LPFC_DEFAULT_MENLO_SG_SEG_CNT) {
-			phba->cfg_sg_seg_cnt = LPFC_DEFAULT_MENLO_SG_SEG_CNT;
-			shost->sg_tablesize = phba->cfg_sg_seg_cnt;
-		}
-	}
-
 	error = scsi_add_host_with_dma(shost, dev, &phba->pcidev->dev);
 	if (error)
 		goto out_put_shost;
@@ -3851,6 +3842,13 @@ lpfc_sli_driver_resource_setup(struct lp
 
 	/* Get all the module params for configuring this host */
 	lpfc_get_cfgparam(phba);
+	if (phba->pcidev->device == PCI_DEVICE_ID_HORNET) {
+		phba->menlo_flag |= HBA_MENLO_SUPPORT;
+		/* check for menlo minimum sg count */
+		if (phba->cfg_sg_seg_cnt < LPFC_DEFAULT_MENLO_SG_SEG_CNT)
+			phba->cfg_sg_seg_cnt = LPFC_DEFAULT_MENLO_SG_SEG_CNT;
+	}
+
 	/*
 	 * Since the sg_tablesize is module parameter, the sg_dma_buf_size
 	 * used to create the sg_dma_buf_pool must be dynamically calculated.
drivers/scsi/lpfc/lpfc_mbox.c +8 -8
diff -upNr a/drivers/scsi/lpfc/lpfc_mbox.c b/drivers/scsi/lpfc/lpfc_mbox.c
@@ -1610,7 +1610,7 @@ lpfc_sli4_mbox_cmd_free(struct lpfc_hba 
 	for (sgentry = 0; sgentry < sgecount; sgentry++) {
 		lpfc_sli4_mbx_sge_get(mbox, sgentry, &sge);
 		phyaddr = getPaddr(sge.pa_hi, sge.pa_lo);
-		dma_free_coherent(&phba->pcidev->dev, PAGE_SIZE,
+		dma_free_coherent(&phba->pcidev->dev, SLI4_PAGE_SIZE,
 				  mbox->sge_array->addr[sgentry], phyaddr);
 	}
 	/* Free the sge address array memory */
@@ -1668,7 +1668,7 @@ lpfc_sli4_config(struct lpfc_hba *phba, 
 	}
 
 	/* Setup for the none-embedded mbox command */
-	pcount = (PAGE_ALIGN(length))/PAGE_SIZE;
+	pcount = (PAGE_ALIGN(length))/SLI4_PAGE_SIZE;
 	pcount = (pcount > LPFC_SLI4_MBX_SGE_MAX_PAGES) ?
 				LPFC_SLI4_MBX_SGE_MAX_PAGES : pcount;
 	/* Allocate record for keeping SGE virtual addresses */
@@ -1683,24 +1683,24 @@ lpfc_sli4_config(struct lpfc_hba *phba, 
 	for (pagen = 0, alloc_len = 0; pagen < pcount; pagen++) {
 		/* The DMA memory is always allocated in the length of a
 		 * page even though the last SGE might not fill up to a
-		 * page, this is used as a priori size of PAGE_SIZE for
+		 * page, this is used as a priori size of SLI4_PAGE_SIZE for
 		 * the later DMA memory free.
 		 */
-		viraddr = dma_alloc_coherent(&phba->pcidev->dev, PAGE_SIZE,
+		viraddr = dma_alloc_coherent(&phba->pcidev->dev, SLI4_PAGE_SIZE,
 					     &phyaddr, GFP_KERNEL);
 		/* In case of malloc fails, proceed with whatever we have */
 		if (!viraddr)
 			break;
-		memset(viraddr, 0, PAGE_SIZE);
+		memset(viraddr, 0, SLI4_PAGE_SIZE);
 		mbox->sge_array->addr[pagen] = viraddr;
 		/* Keep the first page for later sub-header construction */
 		if (pagen == 0)
 			cfg_shdr = (union lpfc_sli4_cfg_shdr *)viraddr;
 		resid_len = length - alloc_len;
-		if (resid_len > PAGE_SIZE) {
+		if (resid_len > SLI4_PAGE_SIZE) {
 			lpfc_sli4_mbx_sge_set(mbox, pagen, phyaddr,
-					      PAGE_SIZE);
-			alloc_len += PAGE_SIZE;
+					      SLI4_PAGE_SIZE);
+			alloc_len += SLI4_PAGE_SIZE;
 		} else {
 			lpfc_sli4_mbx_sge_set(mbox, pagen, phyaddr,
 					      resid_len);
drivers/scsi/lpfc/lpfc_sli.c +35 -12

167 lines not on this page · raw message