omap3: pm: Delink OPP layer from cpufreq

The OPP layer is currently contained in CONFIG_CPU_FREQ. When the ARM frequency is set via bootarg 'mpurate' the OPP layer is required to:
- verify that specified mpurate is valid and available in the OPP table.
- get voltage corresponding to specified frequency.

This is initial attempt to make OPP layer available without cpufreq. Since, this is initial version, i am making changes in board-omap3evm.c only. same change will be required in other board files as well. Will do so in next version of the patch.

I have also updated the OPP tables for OMAP3430 to include support for 720MHz. It will be a separate patch when I submit it next.

[1] http://marc.info/?l=linux-omap&m=127495955603835&w=2

Sanjeev Premi (1):
omap3: pm: Delink opp layer and cpufreq

 arch/arm/mach-omap2/Makefile          |    6 +-
 arch/arm/mach-omap2/board-omap3evm.c  |    2 +-
 arch/arm/mach-omap2/cpufreq34xx.c     |  164 --------------------------------
 arch/arm/mach-omap2/omap3-opp.h       |   20 ----
 arch/arm/mach-omap2/opp34xx_data.c    |  166 +++++++++++++++++++++++++++++++++
 arch/arm/mach-omap2/pm34xx.c          |    1 -
 arch/arm/plat-omap/Makefile           |    7 +-
 arch/arm/plat-omap/cpu-omap.c         |   47 +++++++++
 arch/arm/plat-omap/include/plat/opp.h |   82 +---------------
 arch/arm/plat-omap/opp.c              |   46 ---------
 10 files changed, 225 insertions(+), 316 deletions(-)
 delete mode 100644 arch/arm/mach-omap2/cpufreq34xx.c
 delete mode 100644 arch/arm/mach-omap2/omap3-opp.h
 create mode 100644 arch/arm/mach-omap2/opp34xx_data.c