drm/i915: Configure dither for eDP
Subsystems (2)
PATCH 1/1 drm/i915: Configure dither for eDP
From: Zhao Yakui <[email protected]>
The non-8 BPC can be used for the eDP output device that is connected through DP-A or DP-D on PCH. In such case we should set the PIPECONF dither correctly.
Signed-off-by Zhao Yakui <[email protected]>
Tested-by Jan-Hendrik Zab <[email protected]>
Signed-off-by Zhenyu Wang <[email protected]>
--- drivers/gpu/drm/i915/intel_display.c | 12 ++++++++++++ 1 files changed, 12 insertions(+), 0 deletions(-)
drivers/gpu/drm/i915/intel_display.c +12 -0
@@ -3627,6 +3627,18 @@ static int intel_crtc_mode_set(struct drm_crtc *crtc,/* setup pipeconf */ pipeconf =I915_READ (pipeconf_reg); +/* configure the dither for eDP */ +if (HAS_PCH_SPLIT (dev) && + (is_edp || (is_dp &&intel_pch_has_edp (crtc)))) { + pipeconf &= ~PIPE_DITHER_TYPE_MASK ; +if ((pipeconf &PIPE_BPC_MASK ) !=PIPE_8BPC ) { + pipeconf |=PIPE_ENABLE_DITHER ; + pipeconf |=PIPE_DITHER_TYPE_ST01 ; + }else { + pipeconf &= ~PIPE_ENABLE_DITHER ; + } + } +/* Set up the display plane register */ dspcntr =DISPPLANE_GAMMA_ENABLE ;
Signature · 1 line
1.7.0.4