Skip to contentSkip to conversation

lite5200: fix ethernet phy address

PATCH New Dmitry Eremin-Solenikov 1 participant 1 message Jun 10, 2010

Subsystems (2)
Device tree bindings PowerPC
lore
Share & tools
lore

Dmitry Eremin-Solenikov

author
#0 lore raw

PATCH v2 1/1 lite5200: fix ethernet phy address

According to my schematics, on Lite5200 board ethernet phy uses address 0 (all ADDR lines are pulled down). With this change I can talk to onboard phy (LXT971) and correctly use autonegotiation.

Signed-off-by Dmitry Eremin-Solenikov <[email protected]>
Cc René Bürgel <[email protected]>
Cc Paul Mackerras <[email protected]>
Cc Grant Likely <[email protected]>
Cc Yogesh Chaudhari <[email protected]>
Signed-off-by Dmitry Eremin-Solenikov <[email protected]>
---
 arch/powerpc/boot/dts/lite5200.dts |    4 ++--
 1 files changed, 2 insertions(+), 2 deletions(-)
arch/powerpc/boot/dts/lite5200.dts +2 -2
index 82ff2b1..2b64d8e 100644
@@ -230,8 +230,8 @@
 			reg = <0x3000 0x400>;	// fec range, since we need to setup fec interrupts
 			interrupts = <2 5 0>;	// these are for "mii command finished", not link changes & co.
 
-			phy0: ethernet-phy@1 {
-				reg = <1>;
+			phy0: ethernet-phy@0 {
+				reg = <0>;
 			};
 		};
Signature · 1 line
1.7.1