mtd: cfi_probe: print manufacturer and id of probed chip
PATCH 1/1 mtd: cfi_probe: print manufacturer and id of probed chip
Signed-off-by Guillaume LECERF <[email protected]>
--- drivers/mtd/chips/cfi_probe.c | 4 ++-- 1 files changed, 2 insertions(+), 2 deletions(-)
drivers/mtd/chips/cfi_probe.c +2 -2
@@ -235,9 +235,9 @@ static int __xipram cfi_chip_setup(struct map_info *map,cfi_qry_mode_off (base, map, cfi);xip_allowed (base, map); -printk (KERN_INFO "%s: Found %d x%d devices at 0x%x in %d-bit bank\n" , +printk (KERN_INFO "%s: Found %d x%d devices at 0x%x in %d-bit bank. mfr=0x%08x id=0x%08x\n" , map->name, cfi->interleave, cfi->device_type*8 , base, - map->bankwidth*8 ); + map->bankwidth*8 , cfi->mfr, cfi->id);return 1 ; }
Quoted 10 lines · Guillaume LECERF
Signed-off-by Guillaume LECERF <[email protected]>--- drivers/mtd/chips/cfi_probe.c | 4 ++-- 1 files changed, 2 insertions(+), 2 deletions(-)drivers/mtd/chips/cfi_probe.c +0
-0
drivers/mtd/chips/cfi_probe.c static int __xipram cfi_chip_setup(struct map_info *map, · line 240
Quoted 8 lines
drivers/mtd/chips/cfi_probe.c +2
-2@@ -235,9 +235,9 @@ static int __xipram cfi_chip_setup(struct map_info *map,cfi_qry_mode_off (base, map, cfi);xip_allowed (base, map); -printk (KERN_INFO "%s: Found %d x%d devices at 0x%x in %d-bit bank\n" , +printk (KERN_INFO "%s: Found %d x%d devices at 0x%x in %d-bit bank. mfr=0x%08x id=0x%08x\n" , map->name, cfi->interleave, cfi->device_type*8 , base, - map->bankwidth*8 ); + map->bankwidth*8 , cfi->mfr, cfi->id);
This is not a debugging print, so I think you should do it in a more user-friendly way. E.g., "manufect. ID %#08x, chip id %#08x".
Signature · 2 lines
Best Regards, Artem Bityutskiy (Артём Битюцкий)