zlib: Add further watchdog reset calls
PATCH v2 2/2 zlib: Add further watchdog reset calls
Patch 253cb831 [zlib: add watchdog reset call] added already a few watchdog reset calls to the new zlib U-Boot port. But on some boards this is not enough. Additional calls are needed on boards with short watchdog timeouts.
This was detected and tested on the lwmon5 board with a very short watchdog timeout. Without this patch, the board resets during Linux kernel decompression. With it, the decompression succeeds.
---
v2:
- Changed to use WATCHDOG_RESET macro instead of function pointer
lib/zlib.c | 1 + 1 files changed, 1 insertions(+), 0 deletions(-)
lib/zlib.c +1 -0
@@ -1599,6 +1599,7 @@ int flush; strm->adler = state->check =adler32 (0L ,Z_NULL ,0 ); state->mode =TYPE ;case TYPE : +WATCHDOG_RESET ();if (flush ==Z_BLOCK ) goto inf_leave;case TYPEDO :if (state->last) {
Signature · 1 line
1.7.2.3
PATCH v2 2/2 zlib: Add further watchdog reset calls
Hi Stefan,
Quoted 11 lines
Patch
253cb831[zlib: add watchdog reset call] added already a few watchdog reset calls to the new zlib U-Boot port. But on some boards this is not enough. Additional calls are needed on boards with short watchdog timeouts.This was detected and tested on the lwmon5 board with a very short watchdog timeout. Without this patch, the board resets during Linux kernel decompression. With it, the decompression succeeds.
Signed-off-by Stefan Roese <[email protected]>Cc Detlev Zundel <[email protected]>
Cheers
Detlev
Signature · 7 lines
The 82558 B-step and later generation devices do not maintain a link
in D3 if PME is disabled or if the device does not have power.
-- Intel documentation
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-40 Fax: (+49)-8142-66989-80 Email: dzu at denx.deWolfgang Denk
AppliedPATCH v2 2/2 zlib: Add further watchdog reset calls
In reply to Stefan RoeseDear Stefan Roese,
Quoted 9 lines · In message <[email protected]> you wrote:
Patch
253cb831[zlib: add watchdog reset call] added already a few watchdog reset calls to the new zlib U-Boot port. But on some boards this is not enough. Additional calls are needed on boards with short watchdog timeouts.This was detected and tested on the lwmon5 board with a very short watchdog timeout. Without this patch, the board resets during Linux kernel decompression. With it, the decompression succeeds.
Quoted 8 lines
Signed-off-by Stefan Roese <[email protected]>Cc Detlev Zundel <[email protected]>---
v2:
- Changed to useWATCHDOG_RESETmacro instead of function pointerlib/zlib.c | 1 + 1 files changed, 1 insertions(+), 0 deletions(-)
Applied, thanks.
Best regards,
Wolfgang Denk
Signature · 4 lines
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de If God wanted me to touch my toes, he'd have put them on my knees.