Skip to contentSkip to conversation

Fix typo configue => configure in comments

PATCH Applied Thomas Weber 3 participants 3 messages Sep 22, 2010 – Sep 23, 2010

Subsystems (5)
Networking Sound MIPS ASoC +1 more subsystems
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 Fix typo configue => configure in comments

---
 arch/mips/pci/fixup-fuloong2e.c          |    2 +-
 drivers/net/wireless/hostap/hostap_hw.c  |    2 +-
 net/irda/irnet/irnet_ppp.c               |    2 +-
 sound/soc/s3c24xx/neo1973_gta02_wm8753.c |    2 +-
 sound/soc/s3c24xx/neo1973_wm8753.c       |    2 +-
 5 files changed, 5 insertions(+), 5 deletions(-)
arch/mips/pci/fixup-fuloong2e.c +1 -1
index 4f6d8da..d5d4c01 100644
@@ -52,7 +52,7 @@ static void __init loongson2e_nec_fixup(struct pci_dev *pdev)
 {
 	unsigned int val;
 
-	/* Configues port 1, 2, 3, 4 to be validate*/
+	/* Configures port 1, 2, 3, 4 to be validate*/
 	pci_read_config_dword(pdev, 0xe0, &val);
 	pci_write_config_dword(pdev, 0xe0, (val & ~7) | 0x4);
 
drivers/net/wireless/hostap/hostap_hw.c +1 -1
index e9d9d62..b7cb165 100644
@@ -2621,7 +2621,7 @@ static irqreturn_t prism2_interrupt(int irq, void *dev_id)
 	iface = netdev_priv(dev);
 	local = iface->local;
 
-	/* Detect early interrupt before driver is fully configued */
+	/* Detect early interrupt before driver is fully configured */
 	spin_lock(&local->irq_init_lock);
 	if (!dev->base_addr) {
 		if (net_ratelimit()) {
net/irda/irnet/irnet_ppp.c +1 -1
index dfe7b38..36f43ca 100644
@@ -663,7 +663,7 @@ dev_irnet_ioctl(
       if((val == N_SYNC_PPP) || (val == N_PPP))
 	{
 	  DEBUG(FS_INFO, "Entering PPP discipline.\n");
-	  /* PPP channel setup (ap->chan in configued in dev_irnet_open())*/
+	  /* PPP channel setup (ap->chan in configured in dev_irnet_open())*/
 	  lock_kernel();
 	  err = ppp_register_channel(&ap->chan);
 	  if(err == 0)
sound/soc/s3c24xx/neo1973_gta02_wm8753.c +1 -1
index 209c259..4719558 100644
@@ -182,7 +182,7 @@ static int neo1973_gta02_voice_hw_params(
 	if (ret < 0)
 		return ret;
 
-	/* configue and enable PLL for 12.288MHz output */
+	/* configure and enable PLL for 12.288MHz output */
 	ret = snd_soc_dai_set_pll(codec_dai, WM8753_PLL2, 0,
 		iis_clkrate / 4, 12288000);
 	if (ret < 0)
sound/soc/s3c24xx/neo1973_wm8753.c +1 -1
index 0cb4f86..4ac6209 100644
@@ -201,7 +201,7 @@ static int neo1973_voice_hw_params(struct snd_pcm_substream *substream,
 	if (ret < 0)
 		return ret;
 
-	/* configue and enable PLL for 12.288MHz output */
+	/* configure and enable PLL for 12.288MHz output */
 	ret = snd_soc_dai_set_pll(codec_dai, WM8753_PLL2, 0,
 		iis_clkrate / 4, 12288000);
 	if (ret < 0)
Signature · 1 line
1.7.3