ppc4xx: Fix CATcenter build
PATCH v2 1/1 ppc4xx: Fix CATcenter build
Signed-off-by Stefan Roese <[email protected]>
---
v2:
- MAKEALL change removed
include/configs/CATcenter.h | 23 ++--------------------- 1 files changed, 2 insertions(+), 21 deletions(-)
include/configs/CATcenter.h +2 -21
@@ -105,6 +105,7 @@#define CONFIG_SYS_LOADS_BAUD_CHANGE 1/* allow baudrate change */ +#define CONFIG_PPC4xx_EMAC#undef CONFIG_EXT_PHY#define CONFIG_NET_MULTI 1
@@ -398,6 +399,7 @@* I2C EEPROM (CAT24WC16) for environment */ #define CONFIG_HARD_I2C /* I2c with hardware support */ +#define CONFIG_PPC4XX_I2C /* use PPC4xx driver */ #define CONFIG_SYS_I2C_SPEED 400000/* I2C speed and slave address */ #define CONFIG_SYS_I2C_SLAVE 0x7F
@@ -410,16 +412,6 @@/* last 4 bits of the address */ #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 10/* and takes up to 10 msec */ -/*----------------------------------------------------------------------- -* Cache Configuration -*/ -#define CONFIG_SYS_DCACHE_SIZE 16384/* For AMCC 405 CPUs, older 405 ppc's */ -/* have only 8kB, 16kB is save here */ -#define CONFIG_SYS_CACHELINE_SIZE 32/* ... */ -#if defined(CONFIG_CMD_KGDB ) -#define CONFIG_SYS_CACHELINE_SHIFT 5/* log base 2 of the above value */ -#endif -/* * Init Memory Controller: *
@@ -570,17 +562,6 @@#define DIMM_READ_ADDR 0xAB#define DIMM_WRITE_ADDR 0xAA -#define CPC0_PLLMR0 (CNTRL_DCR_BASE+0x0)/* PLL mode 0 register */ -#define CPC0_BOOT (CNTRL_DCR_BASE+0x1)/* Chip Clock Status register */ -#define CPC0_CR1 (CNTRL_DCR_BASE+0x2)/* Chip Control 1 register */ -#define CPC0_EPRCSR (CNTRL_DCR_BASE+0x3)/* EMAC PHY Rcv Clk Src register */ -#define CPC0_PLLMR1 (CNTRL_DCR_BASE+0x4)/* PLL mode 1 register */ -#define CPC0_UCR (CNTRL_DCR_BASE+0x5)/* UART Control register */ -#define CPC0_SRR (CNTRL_DCR_BASE+0x6)/* Soft Reset register */ -#define CPC0_JTAGID (CNTRL_DCR_BASE+0x7)/* JTAG ID register */ -#define CPC0_SPARE (CNTRL_DCR_BASE+0x8)/* Spare DCR */ -#define CPC0_PCI (CNTRL_DCR_BASE+0x9)/* PCI Control register */ -/* Defines for CPC0_PLLMR1 Register fields */ #define PLL_ACTIVE 0x80000000#define CPC0_PLLMR1_SSCS 0x80000000
Signature · 1 line
1.7.3