usb: usb30 ch11 definitions
PATCH 1/2 usb: usb30 ch11 definitions
Adding hub SuperSpeed usb definitions as defined by ch10 of the USB3.0 spec.
This patch is a preparation for adding SuperSpeed support to the dummy_hcd.
Signed-off-by Tatyana Brokhman <[email protected]>
--- include/linux/usb/ch11.h | 47 ++++++++++++++++++++++++++++++++++++++++++++++ include/linux/usb/hcd.h | 4 +++ 2 files changed, 51 insertions(+), 0 deletions(-)
include/linux/usb/ch11.h +47 -0
@@ -28,6 +28,13 @@#define HUB_STOP_TT 11/* +* Hub class aditional requests defined by USB 3.0 spec +* See USB 3.0 spec Table 10-6 +*/ +#define HUB_SET_DEPTH 12 +#define HUB_GET_PORT_ERR_COUNT 13 + +/* * Hub Class feature numbers * See USB 2.0 spec Table 11-17 */
@@ -83,6 +90,21 @@ struct usb_port_status {/* bits 13 to 15 are reserved */ #define USB_PORT_STAT_SUPER_SPEED 0x8000/* Linux-internal */ + +/* +* Port feature selectors added by USB 3.0 spec. +* See USB 3.0 spec Table 10-7 +*/ +#define USB_PORT_FEAT_LINK_STATE 5 +#define USB_PORT_FEAT_U1_TIMEOUT 23 +#define USB_PORT_FEAT_U2_TIMEOUT 24 +#define USB_PORT_FEAT_C_LINK_STATE 25 +#define USB_PORT_FEAT_C_CONFIG_ERR 26 +#define USB_PORT_FEAT_REMOTE_WAKE_MASK 27 +#define USB_PORT_FEAT_BH_PORT_RESET 28 +#define USB_PORT_FEAT_C_BH_PORT_RESET 29 +#define USB_PORT_FEAT_FORCE_LINKPM_ACCEPT 30 +/* * wPortChange bit field * See USB 2.0 spec Table 11-22
@@ -121,6 +143,31 @@ struct usb_hub_status {#define HUB_CHANGE_LOCAL_POWER 0x0001#define HUB_CHANGE_OVERCURRENT 0x0002 +/* +* Additions to wPortStatus bit filed from USB 3.0 +* See USB 3.0 spec Table 10-10 +*/ +#define USB_PORT_STAT_LINK_STATE 0x01e0 +#define USB_SS_PORT_STAT_POWER 0x0200 +#define USB_PORT_STAT_SPEED_5GBPS 0x0000 +/* Valid only if port is enabled */ + +/* +* Defenitions for PORT_LINK_STATE values +* (bits 5-8) in wPortStatus +*/ +#define USB_SS_PORT_LS_U0 0x0000 +#define USB_SS_PORT_LS_U1 0x0020 +#define USB_SS_PORT_LS_U2 0x0040 +#define USB_SS_PORT_LS_U3 0x0060 +#define USB_SS_PORT_LS_SS_DISABLED 0x0080 +#define USB_SS_PORT_LS_RX_DETECT 0x00a0 +#define USB_SS_PORT_LS_SS_INACTIVE 0x00c0 +#define USB_SS_PORT_LS_POLLING 0x00e0 +#define USB_SS_PORT_LS_RECOVERY 0x0100 +#define USB_SS_PORT_LS_HOT_RESET 0x0120 +#define USB_SS_PORT_LS_COMP_MOD 0x0140 +#define USB_SS_PORT_LS_LOOPBACK 0x0160/* * Hub descriptor
include/linux/usb/hcd.h +4 -0
@@ -469,6 +469,10 @@ extern void usb_ep0_reinit(struct usb_device *);/*-------------------------------------------------------------------------*/ +/* class requests from USB 3.0 hub spec, table 10-5 */ +#define SetHubDepth (0x3000 | HUB_SET_DEPTH) +#define GetPortErrorCount (0x8000 | HUB_GET_PORT_ERR_COUNT) +/* * Generic bandwidth allocation constants/support */
Signature · 5 lines
1.6.3.3 -- Sent by an consultant of the Qualcomm Inovation Center, Inc. The Qualcomm Inovation Center, Inc.is a member of the Code Aurora Forum.