Skip to contentSkip to conversation

Add board support for hawkboard

PATCH Superseded Sughosh Ganu 1 participant 1 message Nov 1, 2010 Arm (32-bit)

v5 of 6 Superseded Latest is v6 →

lore
Share & tools
lore
#0 lore raw

PATCH v5 3/3 Add board support for hawkboard

The patch adds basic board support for TI's OMAP-L138 based Hawkboard. This board is pretty similar to the da850 EVM. Support for nand and network access is added in this version.

The following bootup procedure is used.

At reset, the Rom Boot Loader(RBL), initialises the ddr and the nand controllers and copies the second stage bootloader(nand_spl) to RAM. The secondary bootloader then copies u-boot from a predefined location in the nand flash to the RAM, and passes control to the u-boot image.

Three config options are supported
* hawkboard_config - Used to create the u-boot.bin. Tftp the u-boot.bin image to the RAM from u-boot, and flash to the nand flash at address 0xe0000.

* hawkboard_nand_config - Used to generate the secondary bootloader(nand_spl) image. This creates an elf file u-boot-spl under nand_spl/. Create an AIS signed image using this file, and flash it to the nand flash at address 0x20000. The ais file should fit in one block.

* hawkboard_uart_config - This is same as the first image, but with the TEXT_BASE as expected by the RBL(0xc1080000). Create the AIS Signed bin, as use the normal UART boot procedure to boot the image.

---
Changes since V4
* Replaced CONFIG_SYS_GBL_DATA_SIZE with GENERATED_GBL_DATA_SIZE
* Removed the superfluous call to relocate_code in nand_spl

 MAINTAINERS                                      |    5 +
 arch/arm/include/asm/arch-davinci/da8xx_common.h |    3 +
 arch/arm/include/asm/arch-davinci/hardware.h     |    5 +-
 board/davinci/common/Makefile                    |    2 +-
 board/davinci/common/davinci_pinmux.c            |  105 +++++++++++
 board/davinci/common/misc.c                      |   75 --------
 board/davinci/da8xxevm/Makefile                  |    1 +
 board/davinci/da8xxevm/hawkboard.c               |   69 ++++++++
 board/davinci/da8xxevm/hawkboard_nand_spl.c      |  158 +++++++++++++++++
 boards.cfg                                       |    3 +
 doc/README.hawkboard                             |   93 ++++++++++
 include/configs/hawkboard.h                      |  200 ++++++++++++++++++++++
 nand_spl/board/davinci/da8xxevm/Makefile         |  141 +++++++++++++++
 nand_spl/board/davinci/da8xxevm/u-boot.lds       |   75 ++++++++
 nand_spl/nand_boot.c                             |    1 +
 15 files changed, 859 insertions(+), 77 deletions(-)
 create mode 100644 board/davinci/common/davinci_pinmux.c
 create mode 100644 board/davinci/da8xxevm/hawkboard.c
 create mode 100644 board/davinci/da8xxevm/hawkboard_nand_spl.c
 create mode 100644 doc/README.hawkboard
 create mode 100644 include/configs/hawkboard.h
 create mode 100644 nand_spl/board/davinci/da8xxevm/Makefile
 create mode 100644 nand_spl/board/davinci/da8xxevm/u-boot.lds
MAINTAINERS +5 -0
index 9258cb1..2a7d23d 100644
@@ -851,6 +851,11 @@ Alex Z
 	lart		SA1100
 	dnp1110		SA1110
 
+Syed Mohammed Khasim <[email protected]>
+Sughosh Ganu <[email protected]>
+
+	hawkboard	ARM926EJS (OMAP-L138)
+
 -------------------------------------------------------------------------
 
 Unknown / orphaned boards:
arch/arm/include/asm/arch-davinci/da8xx_common.h +3 -0
index 7ae63a6..bc3092d 100644
@@ -19,6 +19,9 @@
 #ifndef __COMMON_H
 #define __COMMON_H
 
+#define	HAWKBOARD_KICK0_UNLOCK		0x83e70b13
+#define	HAWKBOARD_KICK1_UNLOCK		0x95a4f1e0
+
 struct lpsc_resource {
 	const int	lpsc_no;
 };
arch/arm/include/asm/arch-davinci/hardware.h +4 -1
index 3520cf8..d006ac1 100644
@@ -379,7 +379,10 @@ int clk_get(enum davinci_clk_ids id);
 /* Boot config */
 struct davinci_syscfg_regs {
 	dv_reg	revid;
-	dv_reg	rsvd[71];
+	dv_reg	rsvd[13];
+	dv_reg	kick0;
+	dv_reg	kick1;
+	dv_reg	rsvd1[56];
 	dv_reg	pinmux[20];
 	dv_reg	suspsrc;
 	dv_reg	chipsig;
board/davinci/common/Makefile +1 -1
index 8d9ea00..dd022f6 100644
@@ -29,7 +29,7 @@ endif
 
 LIB	= $(obj)lib$(VENDOR).a
 
-COBJS	:= misc.o
+COBJS	:= misc.o davinci_pinmux.o
 
 SRCS	:= $(SOBJS:.o=.S) $(COBJS:.o=.c)
 OBJS	:= $(addprefix $(obj),$(COBJS))
board/davinci/common/davinci_pinmux.c new file +105 -0

105 lines not on this page · raw message

board/davinci/common/misc.c +0 -75

78 lines not on this page · raw message

board/davinci/da8xxevm/Makefile +1 -0
index 17cbe86..1a67351 100644
@@ -30,6 +30,7 @@ LIB	= $(obj)lib$(BOARD).a
 COBJS-y	+= common.o
 COBJS-$(CONFIG_MACH_DAVINCI_DA830_EVM)	+= da830evm.o
 COBJS-$(CONFIG_MACH_DAVINCI_DA850_EVM)	+= da850evm.o
+COBJS-$(CONFIG_MACH_DAVINCI_HAWK)	+= hawkboard.o
 
 COBJS   := $(COBJS-y)
 
board/davinci/da8xxevm/hawkboard.c new file +69 -0

69 lines not on this page · raw message

board/davinci/da8xxevm/hawkboard_nand_spl.c new file +158 -0

158 lines not on this page · raw message

boards.cfg +3 -0
index 6c2a667..e2c73eb 100644
@@ -372,6 +372,9 @@ davinci_sffsdr	arm	arm926ejs	sffsdr		davinci		davinci
 davinci_sonata	arm	arm926ejs	sonata		davinci		davinci
 da830evm	arm	arm926ejs	da8xxevm	davinci		davinci
 da850evm	arm	arm926ejs	da8xxevm	davinci		davinci
+hawkboard	arm	arm926ejs	da8xxevm	davinci		davinci		hawkboard:SYS_TEXT_BASE=0xc1180000
+hawkboard_nand	arm	arm926ejs	da8xxevm	davinci		davinci		hawkboard:SYS_TEXT_BASE=0xc1080000,NAND_U_BOOT
+hawkboard_uart	arm	arm926ejs	da8xxevm	davinci		davinci		hawkboard:SYS_TEXT_BASE=0xc1080000
 guruplug	arm	arm926ejs	-		Marvell		kirkwood
 mv88f6281gtw_ge	arm	arm926ejs	-		Marvell		kirkwood
 openrd_base	arm	arm926ejs	-		Marvell		kirkwood
doc/README.hawkboard new file +93 -0

93 lines not on this page · raw message

include/configs/hawkboard.h new file +200 -0

200 lines not on this page · raw message

nand_spl/board/davinci/da8xxevm/Makefile new file +141 -0

141 lines not on this page · raw message

nand_spl/board/davinci/da8xxevm/u-boot.lds new file +75 -0

75 lines not on this page · raw message

nand_spl/nand_boot.c +1 -0
index b9fd6f5..76b8566 100644
@@ -236,6 +236,7 @@ void nand_boot(void)
 	/*
 	 * Init board specific nand support
 	 */
+	nand_chip.select_chip = NULL;
 	nand_info.priv = &nand_chip;
 	nand_chip.IO_ADDR_R = nand_chip.IO_ADDR_W = (void  __iomem *)CONFIG_SYS_NAND_BASE;
 	nand_chip.dev_ready = NULL;	/* preset to NULL */
Signature · 1 line
1.7.0.4