Make the ip6_tunnel reflect the true mtu.
Subsystems (3)
PATCH 1/1 Make the ip6_tunnel reflect the true mtu.
The ip6_tunnel always assumes it consumes 40 bytes (ip6 hdr) of the mtu of the underlaying device. So for a normal ethernet bearer, the mtu of the ip6_tunnel is 1460.
However, when creating a tunnel the encap limit option is enabled by default, and it consumes 8 bytes more, so the true mtu shall be 1452.
I dont really know if this breaks some statement in some RFC, so this is a request for comments.
Signed-off-by Anders Franzen <[email protected]>
--- net/ipv6/ip6_tunnel.c | 7 +++++++ 1 files changed, 7 insertions(+), 0 deletions(-)
net/ipv6/ip6_tunnel.c +7 -0
@@ -1175,6 +1175,8 @@ static void ip6_tnl_link_config(struct ip6_tnl *t)sizeof (struct ipv6hdr ); dev->mtu = rt->rt6i_dev->mtu -sizeof (struct ipv6hdr ); +if (!(t->parms.flags &IP6_TNL_F_IGN_ENCAP_LIMIT )) + dev->mtu-=8 ;if (dev->mtu <IPV6_MIN_MTU ) dev->mtu =IPV6_MIN_MTU ;
@@ -1363,12 +1365,17 @@ static const struct net_device_ops ip6_tnl_netdev_ops = {static void ip6_tnl_dev_setup (struct net_device *dev) { +struct ip6_tnl *t =NULL ; + dev->netdev_ops = &ip6_tnl_netdev_ops; dev->destructor = ip6_dev_free; dev->type =ARPHRD_TUNNEL6 ; dev->hard_header_len =LL_MAX_HEADER +sizeof (struct ipv6hdr ); dev->mtu =ETH_DATA_LEN -sizeof (struct ipv6hdr ); + t =netdev_priv (dev); +if (!(t->parms.flags &IP6_TNL_F_IGN_ENCAP_LIMIT )) + dev->mtu-=8 ; dev->flags |=IFF_NOARP ; dev->addr_len =sizeof (struct in6_addr ); dev->features |=NETIF_F_NETNS_LOCAL ;
Signature · 1 line
1.7.2.3