meta-crownbay: update README
PATCH 1/1 meta-crownbay: update README
Update the crownbay README with information explaining the available machine configurations.
Signed-off-by Tom Zanussi <[email protected]>
--- meta-crownbay/README | 36 +++++++++++++++++++++++++++++++++--- 1 files changed, 33 insertions(+), 3 deletions(-)
meta-crownbay/README +33 -3
@@ -1,5 +1,27 @@ This README file contains information on building the meta-crownbay -BSP layer, and booting the images contained in the /binary directory. +BSP layer using any of the supported machine configurations, and +booting the images contained in the /binary directory. + +The meta-crownbay layer contains support for 2 different machine +configurations, identical except for the fact that one ('crownbay') +makes use of the Intel-proprietary EMGD 1.5 graphics driver, and the +other ('crownbay-noemgd') does not. + +The default 'crownbay' configuration requires an extra manual step +before building in order for the build to complete. Please see +section II below for details. + +The 'crownbay-noemgd' configuration doesn't require any special setup, +but since it uses generic vesa, the graphics aren't as nice and don't +perform as well as the 'crownbay', which does make use of the EMGD +graphics driver. + +If you're only interested in booting the images in the /binary +directory of a BSP tarball you've downloaded, there's nothing special +to do - the appropriate images (for either normal or -noemgd) are +already in the /binary directory depending on which BSP tarball you +downloaded. + Please see the corresponding sections below for details.
@@ -7,7 +29,8 @@ Table of Contents ================= I. Building the meta-crownbay BSP layer - II. Special notes for building the meta-crownbay BSP layer + II. Special notes for building the meta-crownbay BSP layer (with EMGD + graphics) III. Booting the images in /binary
@@ -31,10 +54,16 @@ bblayers.conf e.g.: yocto/meta-intel/meta-crownbay \ -To enable the crownbay layer, add the crownbay MACHINE to local.conf: +To enable the crownbay (with EMGD graphics) layer, add the crownbay +MACHINE to local.conf: MACHINE ?= "crownbay" +To enable the crownbay-noemgd layer, add the crownbay-noemgd MACHINE +to local.conf: + + MACHINE ?= "crownbay-noemgd" + You should then be able to build a crownbay image as such: $ source poky-init-build-env
@@ -46,6 +75,7 @@ that below, in the section 'Booting the images from /binary'). II. Special notes for building the meta-crownbay BSP layer + (with EMGD graphics) ========================================================== The meta-crownbay layer makes use of the proprietary Intel EMGD
Signature · 1 line
1.7.0.4