sparc: use trapbase in setup_arch
PATCH 1/1 sparc: use trapbase in setup_arch
start and trapbase point to the same address.
But using start to assing to sparc_ttable looked confusing.
Replace this with the use of trapbase.
Signed-off-by Sam Ravnborg <[email protected]>
--- arch/sparc/kernel/setup_32.c | 3 +-- 1 files changed, 1 insertions(+), 2 deletions(-)
arch/sparc/kernel/setup_32.c +1 -2
@@ -185,7 +185,6 @@ static void __init boot_flags_init(char *commands)extern void sun4c_probe_vac (void );extern char cputypval; -extern unsigned long start, end;extern unsigned short root_flags;extern unsigned short root_dev;
@@ -210,7 +209,7 @@ void __init setup_arch(char **cmdline_p)int i;unsigned long highest_paddr; - sparc_ttable = (struct tt_entry *) &start; + sparc_ttable = (struct tt_entry *) &trapbase;/* Initialize PROM console and command line. */ *cmdline_p =prom_getbootargs ();
Signature · 1 line
1.6.0.6