fsl: update CRC after system EEPROM identifier
PATCH 1/1 fsl: update CRC after system EEPROM identifier
The "mac id" command is used to initialize the EEPROM data to a specific format, but it was not updating the CRC. This didn't cause any real problems, because writing the data to the EEPROM will always update the CRC anyway, but it did result in a bogus CRC warning.
--- board/freescale/common/sys_eeprom.c | 1 + 1 files changed, 1 insertions(+), 0 deletions(-)
board/freescale/common/sys_eeprom.c +1 -0
@@ -361,6 +361,7 @@ int do_mac(cmd_tbl_t *cmdtp, int flag, int argc, char * const argv[])#else memcpy (e.id,"CCID" ,sizeof (e.id));#endif +update_crc ();return 0 ; }
Signature · 1 line
1.7.3.4
PATCH 1/1 fsl: update CRC after system EEPROM identifier
Quoted 7 lines · Timur Tabi
The "mac id" command is used to initialize the EEPROM data to a specific format, but it was not updating the CRC. ?This didn't cause any real problems, because writing the data to the EEPROM will always update the CRC anyway, but it did result in a bogus CRC warning.
Signed-off-by Timur Tabi <[email protected]>---
That should say, "after setting EEPROM identifier"
Signature · 2 lines
Timur Tabi Linux kernel developer at Freescale
PATCH 1/1 fsl: update CRC after system EEPROM identifier
Quoted 10 lines · Timur Tabi
Quoted 7 lines · Timur Tabi
The "mac id" command is used to initialize the EEPROM data to a specific format, but it was not updating the CRC. This didn't cause any real problems, because writing the data to the EEPROM will always update the CRC anyway, but it did result in a bogus CRC warning.
Signed-off-by Timur Tabi <[email protected]>---
That should say, "after setting EEPROM identifier"
Fixed, committed to 85xx
- k